Effects of Alumina Films on N-Doped Carbon Nanotubes/Graphene Composites as Anode Materials of Lithium-Ion Batteries
Authors:
Open Access
- 28 November 2020
- journal article
- research article
- Published by Wiley in Journal of Nanomaterials
- Vol. 2020, 1-13
Abstract
A carbon nanotubes/graphene composite is grown on nickel foil without additional catalysts by one-step ambient pressure chemical vapor deposition (CVD). Next, the carbon nanotubes/graphene composite is modified by radio frequency (RF) nitrogen plasma. Finally, to improve its initial coulombic efficiency/electrochemical stability, lower potential during the charge process (coin cell), and boost potential during the discharge process (lithium-ion battery), alumina is deposited onto the N-doped carbon nanotubes/graphene composite by RF magnetron sputtering at different power levels and periods of time. The charge specific capacity (597 mAh/g) and initial coulombic efficiency (81.44% > 75.02% for N-doped carbon nanotubes/graphene) of Al2O3/N-doped CNTs/graphene for the coin cell reached a maximum at the best sputtering condition ( and ). Al2O3/N-doped CNTs/graphene (the best sputtering condition) exhibits higher initial coulombic efficiency (79.8%) compared with N-doped CNTs/graphene (initial coulombic efficiency: 74.3%) for the lithium-ion battery. Furthermore, the achievement fraction (about 70%) of full charge capacity (coin cell) for Al2O3/N-doped carbon nanotubes/graphene (the best sputtering condition) is higher than that (about 30%) for N-doped carbon nanotubes/graphene at a voltage lower than about 0.25 V. Moreover, it also shows a little higher electrochemical stability (coin cell) of charge capacity for Al2O3/N-doped carbon nanotubes/graphene (the best sputtering condition) in comparison with N-doped carbon nanotubes/graphene and Al2O3/N-doped CNTs/graphene (the best sputtering condition) exhibits better cyclic stability (lithium-ion battery) of discharge capacity compared with N-doped CNTs/graphene.Keywords
Funding Information
- Ministry of Science and Technology of the People's Republic of China (MOST 109-2221-E-224-008)
This publication has 15 references indexed in Scilit:
- Precise growth of Al2O3/SnO2/CNTs composites by a two-step atomic layer deposition and their application as an improved anode for lithium ion batteriesElectrochimica Acta, 2019
- Porous Al/Al2O3 two-phase nanonetwork to improve electrochemical properties of porous C/SiO2 as anode for Li-ion batteriesElectrochimica Acta, 2019
- Effect of passivating Al2O3 thin films on MnO2/carbon nanotube composite lithium-ion battery anodesJournal of Nanoparticle Research, 2018
- Synthesis of Carbon Nanotube/Graphene Composites on Ni Foam without Additional Catalysts by CVD and their Nitrogen-Plasma Treatment for Anode Materials in Lithium-ion BatteriesElectrochemistry, 2018
- Long lifespan lithium metal anodes enabled by Al2O3 sputter coatingEnergy Storage Materials, 2018
- Low-Cost Al2O3 Coating Layer As a Preformed SEI on Natural Graphite Powder To Improve Coulombic Efficiency and High-Rate Cycling Stability of Lithium-Ion BatteriesACS Applied Materials & Interfaces, 2016
- An Alumina-Coated Fe3O4-Reduced Graphene Oxide Composite Electrode as a Stable Anode for Lithium-ion BatteryElectrochimica Acta, 2015
- Lithium ion rechargeable batteries: State of the art and future needs of microscopic theoretical models and simulationsJournal of Electroanalytical Chemistry, 2015
- Alumina‐Coated Patterned Amorphous Silicon as the Anode for a Lithium‐Ion Battery with High Coulombic EfficiencyAdvanced Materials, 2011
- Ultrathin alumina-coated carbon nanotubes as an anode for high capacity Li-ion batteriesJournal of Materials Chemistry, 2011