Visualization and quantification of melt flow dynamics for laser welding with superimposed intensity distributions analyzed by synchrotron radiation imaging
Open Access
- 23 June 2026
- journal article
- research article
- Published by Springer Nature in Lasers in Manufacturing and Materials Processing
- Vol. 13 (3) , 1-25
Abstract
Modern solid-state lasers enable a continuous increase in welding speed due to higher possible laser beam powers. However, welding speeds above 8 m/min for high-alloy steels lead to altered melt flow dynamics and increased spatter formation, resulting in spatter adhesion and particularly in undercuts along the weld seam. In contrast to the cost- or time-intensive methods described in the state of the art to reduce these effects, modifying the intensity distributions appears to be a simple and effective approach that is independent of the welding direction. In particular, using a superimposed intensity allows a detailed investigation by adjusting the intensity with varying spot sizes or laser powers. Using a superimposed intensity to widen up the melt pool is especially effective in reducing the velocity of the melt flow around the keyhole and, consequently, spatter formation. However, its effect on other melt pool flows, especially the upward directed melt flow along the keyhole rear wall, remains largely unknown. To investigate these effects, high-speed synchrotron X-ray imaging in combination with tungsten carbide tracer particles was used to visualize the melt flow dynamics. Generally, two melt vortices are observed in the area behind the keyhole, one in the upper and one in the lower part of the melt pool. The backward melt flow at the melt pool bottom is unaffected by the additional energy input due to the limited penetration depth of the second laser. Furthermore, the upward directed flow along the keyhole rear wall remains unchanged. When increasing the second laser power, the keyhole widens and fluctuates at the rear wall. As a result, the upward melt flow at the rear wall is not discernible. In general, the superimposed intensity alters the melt flow behind the keyhole. However, these changes appear to be minor significant for spatter formation compared to the flow around the keyhole.Keywords
Funding Information
- Technische Universität Ilmenau
This publication has 39 references indexed in Scilit:
- Synchrotron radiation imaging-based understanding of spatter reduction condition in laser beam keyhole welding of austenitic stainless steels through superimposed intensitiesOptics & Laser Technology, 2026
- Numerical investigation on the molten pool and keyhole dynamic behaviors and weld microstructure in laser-induction hybrid welding of stainless steelInternational Journal of Heat and Mass Transfer, 2025
- Effect of partial and global shielding on surface-driven phenomena in keyhole mode laser beam weldingWelding in the World, 2023
- Materialbearbeitung mit Laser2023
- Influence of dynamic beam shaping on the geometry of the keyhole during laser beam weldingProcedia CIRP, 2022
- Laser beam welding setup for the coaxial combination of two laser beams to vary the intensity distributionWelding in the World, 2022
- Material ejection attempts during laser keyhole weldingJournal of Manufacturing Processes, 2021
- Melt flow regularity and hump formation process during laser deep penetration weldingOptics & Laser Technology, 2021
- Scaling laws for the laser welding process in keyhole modeJournal of Materials Processing Technology, 2019
- Werkstoffkunde2005