Numerical simulation of heat transfer from a transonic jet impinging on skin for needle-free powdered drug and vaccine delivery
Authors:
- 1 November 2004
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
- Vol. 218 (11) , 1373-1383
Abstract
In this paper, gas dynamics and temperature distribution of a transient impinging jet, typically used to deliver powdered drug or vaccines ballistically to the skin, have been numerically simulated. Calculations were performed with the unsteady compressible Navier-Stokes equations, solved using a modified implicit flux vector splitting (MIFVS) difference scheme with a modified k-e model. After validation against an experimental underexpanded jet-flow test cast, the code was applied to two biolistic configurations. Firstly, calculated pressure histories were compared with corresponding measurements in an unsilenced biolistic device, with good agreement. Secondly, this calculation was extended to a silenced geometry, with an emphasis on the gas properties immediately above a skin target. A peak stagnation gas temperature of 420°C is revealed within 175 μs of diaphragm rupture. The temperature of the following driver helium gas suddenly drops to below - 100°C before approaching ambient temperature within 1 ms. The effect of this impinging jet on the human skin is subsequently explored by a one-dimensional convection heat transfer model. On the skin surface, a peak fluctuation of [+5.5°C, - 4.5°C] is.recorded during the operation process. Beyond the outer skin layer, called the stratum corneum (i.e. > 10.6μ), temperature deviations from the normal condition are trivial. Therefore, the heat transfer between the biolistic jet and skin is negligible. This result is consistent with pain-free clinical trial observations.Keywords
This publication has 18 references indexed in Scilit:
- Intradermal ballistic delivery of micro-particles into excised human skin for pharmaceutical applicationsJournal of Biomechanics, 2004
- Effects of Relative Humidity and Ambient Temperature on the Ballistic Delivery of Micro-Particles to Excised Porcine SkinJournal of Investigative Dermatology, 2004
- A ballistic study of micro-particle penetration to the oral mucosaInternational Journal of Impact Engineering, 2003
- Heat transfer predictions with a cubic k–ε model for axisymmetric turbulent jets impinging onto a flat plateInternational Journal of Heat and Mass Transfer, 2003
- Impingement heat transfer in an under-expanded axisymmetric air jetInternational Journal of Heat and Mass Transfer, 2003
- Numerical study of turbulent heat transfer in confined and unconfined impinging jetsInternational Journal of Heat and Fluid Flow, 1999
- Single-Phase Liquid Jet Impingement Heat Transfer1995
- Shock tube study of the drag coefficient of a sphere in a non-stationary flowProceedings of the Royal Society of London. Series A: Mathematical and Physical Sciences, 1993
- Heat transfer to impinging isothermal gas and flame jetsExperimental Thermal and Fluid Science, 1993
- A review of heat transfer data for single circular jet impingementInternational Journal of Heat and Fluid Flow, 1992