The effect of deformation twinning on stress localization in a three dimensional TWIP steel microstructure
Open Access
- 23 April 2015
- journal article
- Published by IOP Publishing in Modelling and Simulation in Materials Science and Engineering
- Vol. 23 (4)
Abstract
We present an investigation of the effect of deformation twinning on the visco-plastic response and stress localization in a low stacking fault energy twinning-induced plasticity (TWIP) steel under uniaxial tension loading. The three-dimensional full field response was simulated using the fast Fourier transform method. The initial microstructure was obtained from a three dimensional serial section using electron backscatter diffraction. Twin volume fraction evolution upon strain was measured so the hardening parameters of the simple Voce model could be identified to fit both the stress-strain behavior and twinning activity. General trends of texture evolution were acceptably predicted including the typical sharpening and balance between the 〈1 1 1〉 fiber and the 〈1 0 0〉 fiber. Twinning was found to nucleate preferentially at grain boundaries although the predominant twin reorientation scheme did not allow spatial propagation to be captured. Hot spots in stress correlated with the boundaries of twinned voxel domains, which either impeded or enhanced twinning based on which deformation modes were active locally.Funding Information
- US Department of Energy (DESC0002001)
- National Science Foundation (CMMI-1235009)
- Australian Research Council
This publication has 47 references indexed in Scilit:
- Orientation dependence of twinning and strain hardening behaviour of a high manganese twinning induced plasticity steel with polycrystalline structureActa Materialia, 2011
- Texture evolution via combined slip and deformation twinning in rolled silver–copper cast eutectic nanocompositeInternational Journal of Plasticity, 2011
- A crystal plasticity theory for latent hardening by glide twinning through dislocation transmutation and twin accommodation effectsJournal of the Mechanics and Physics of Solids, 2010
- Overview of constitutive laws, kinematics, homogenization and multiscale methods in crystal plasticity finite-element modeling: Theory, experiments, applicationsActa Materialia, 2010
- Enhanced Mechanical Properties of a Novel High-Nitrogen Cr-Mn-Ni-Si Austenitic Stainless Steel via TWIP/TRIP EffectsMetallurgical and Materials Transactions A, 2009
- High strength Fe–Mn–(Al, Si) TRIP/TWIP steels development — properties — applicationInternational Journal of Plasticity, 2000
- Influence of grain size and stacking-fault energy on deformation twinning in fcc metalsMetallurgical and Materials Transactions A, 1999
- Deformation twinningProgress in Materials Science, 1995
- A model for texture development dominated by deformation twinning: Application to zirconium alloysActa Metallurgica et Materialia, 1991
- Simulation of the rolling and shear texture of brass by the Taylor theory adapted for mechanical twinningActa Metallurgica, 1978