The Optimization of Process Parameters and Microstructural Characterization of Fiber Laser Welded Dissimilar HSLA and MART Steel Joints
Open Access
Abstract
Nowadays, environmental impact, safety and fuel efficiency are fundamental issues for the automotive industry. These objectives are met by using a combination of different types of steels in the auto bodies. Therefore, it is important to have an understanding of how dissimilar materials behave when they are welded. This paper presents the process parameters’ optimization procedure of fiber laser welded dissimilar high strength low alloy (HSLA) and martensitic steel (MART) steel using a Taguchi approach. The influence of laser power, welding speed and focal position on the mechanical and microstructural properties of the joints was determined. The optimum parameters for the maximum tensile load-minimum heat input were predicted, and the individual significance of parameters on the response was evaluated by ANOVA results. The optimum levels of the process parameters were defined. Furthermore, microstructural examination and microhardness measurements of the selected welds were conducted. The samples of the dissimilar joints showed a remarkable microstructural change from nearly fully martensitic in the weld bead to the unchanged microstructure in the base metals. The heat affected zone (HAZ) region of joints was divided into five subzones. The fusion zone resulted in an important hardness increase, but the formation of a soft zone in the HAZ region.Keywords
This publication has 36 references indexed in Scilit:
- A study of the softening mechanisms of laser-welded DP1000 steel butt jointsMaterials & Design, 2016
- Effect of energy input on the microstructure and properties of butt joints in DP1000 steel laser weldingMaterials & Design, 2016
- Investigation on dissimilar laser welding of advanced high strength steel sheets for the automotive industryMaterials Science and Engineering: A, 2015
- Strain rate dependent deformation and failure behavior of laser welded DP780 steel joint under dynamic tensile loadingMaterials Science and Engineering: A, 2015
- Microstructural and mechanical characterisation of laser-welded lap joints with linear and circular beads in thin low carbon steel sheetsMaterials & Design (1980-2015), 2014
- Microstructure-properties correlation in fiber laser welding of dual-phase and HSLA steelsMaterials Science and Engineering: A, 2014
- Tensile properties of fiber laser welded joints of high strength low alloy and dual-phase steels at warm and low temperaturesMaterials & Design (1980-2015), 2014
- Microstructure and fatigue properties of fiber laser welded dissimilar joints between high strength low alloy and dual-phase steelsMaterials & Design (1980-2015), 2013
- Tensile and fatigue properties of fiber laser welded high strength low alloy and DP980 dual-phase steel jointsMaterials & Design (1980-2015), 2013
- Advanced high strength steels for automotive industryArchives of Civil and Mechanical Engineering, 2008