Residual stress measurement method in MEMS microbeams using frequency shift data
Authors:
- Aurelio SomàAurelio Somà
- Alberto BallestraABAlberto Ballestra
- 1 September 2009
- journal article
- Published by IOP Publishing in Journal of Micromechanics and Microengineering
- Vol. 19 (9)
Abstract
No abstract availableKeywords
This publication has 29 references indexed in Scilit:
- Numerical and experimental comparison of MEMS suspended plates dynamic behaviour under squeeze film damping effectAnalog Integrated Circuits and Signal Processing, 2008
- Comparative numerical study of FEM methods solving gas damping in perforated MEMS devicesMicrofluidics and Nanofluidics, 2008
- Non-linear vibrations and frequency response analysis of piezoelectrically driven microcantileversInternational Journal of Non-Linear Mechanics, 2007
- An effective method of determining the residual stress gradients in a micro-cantileverMicrosystem Technologies, 2005
- Selection of mold materials for electroforming of monolithic two-layer microstructureMicrosystem Technologies, 2004
- Thin films stress extraction using micromachined structures and wafer curvature measurementsMicroelectronic Engineering, 2004
- Electromechanical model of RF MEMS switchesMicrosystem Technologies, 2003
- Effect of experimental pre–stress and residual stress on modal behaviourPhilosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Sciences, 2001
- M-TEST: A test chip for MEMS material property measurement using electrostatically actuated test structuresJournal of Microelectromechanical Systems, 1997
- Post buckling of micromachined beamsJournal of Micromechanics and Microengineering, 1994