Lifetime behavior of a PEM fuel cell with low humidification of feed stream
- 14 December 2004
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 7 (2) , 373-378
Abstract
A 2520 h lifetime test of a single proton exchange membrane (PEM) fuel cell under low humidification (65.8% relative humidity for both anode and cathode feed stream) at a low current density of 200 or 300 mA cm−2 was conducted. H2 crossover rate through electrolyte membrane and open circuit voltage of the cell with time were measured to understand the membrane degradation in the membrane electrode assembly (MEA) during the life test. The results show that low humidification of feed stream accelerates membrane physical degradation, and results in membrane pin-holes and reactant gas crossover. A novel sub-cell approach coupled with SEM and TEM were employed as post mortem analyses. The performance of the sub-cell at H2 inlet region is unacceptably lower than that at the H2 outlet region. SEM images of the used MEA in cross-section apparently revealed that membrane thinning occurred mainly at the H2 inlet region. TEM analysis of the electrocatalysts in the pre- and post-test cell demonstrated that the agglomeration of the Pt particles took place both at the anode and the cathode. Therefore, the non-uniform degradation of electrolyte membrane and the agglomeration of Pt catalysts are concurrently responsible for the degraded performance of the PEM fuel cell.Keywords
This publication has 14 references indexed in Scilit:
- Aging mechanisms and lifetime of PEFC and DMFCJournal of Power Sources, 2004
- Degradation Study of MEA for PEMFCs under Low Humidity ConditionsElectrochemical and Solid-State Letters, 2004
- Catalyst Microstructure Examination of PEMFC Membrane Electrode Assemblies vs. TimeJournal of the Electrochemical Society, 2004
- Studies on performance degradation of a direct methanol fuel cell (DMFC) in life testPhysical Chemistry Chemical Physics, 2003
- Performance and lifetime analysis of the kW-class PEMFC stackJournal of Power Sources, 2002
- An Electrochemical Method to Improve the Performance of Air Cathodes and Methanol AnodesElectrochemical and Solid-State Letters, 2002
- Materials for fuel-cell technologiesNature, 2001
- Performance and endurance of a PEMFC operated with synthetic reformate fuel feedJournal of Power Sources, 1998
- Low platinum loading electrodes for polymer electrolyte fuel cells fabricated using thermoplastic ionomersElectrochimica Acta, 1995
- Analysis of proton exchange membrane fuel cell performance with alternate membranesElectrochimica Acta, 1995