Rapid density-measurement system with vibrating-tube densimeter
Authors:
- 20 August 2003
- journal article
- conference paper
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 74 (9) , 4134-4139
Abstract
Concerning an increasing demand for environmentally friendly refrigerants including hydrocarbons, thermodynamic properties of such new refrigerants, especially densities, are essential information for refrigeration engineering. A rapid density-measurement system with vibrating-tube densimeter was developed in the present study with an aim to supply large numbers of high-quality PVT property data in a short period. The present system needs only a few minutes to obtain a single datum, and requires less than sample fluid. PVT properties in the entire fluid-phase, vapor-pressures, saturated-liquid densities for pure fluid are available. Liquid densities, bubble-point pressures and saturated-liquid densities for mixture can be obtained. The measurement range is from 240 to 380 K for temperature and up to 7 MPa for pressure. By employing a new calibration function, density can be precisely obtained even at lower densities. The densimeter is calibrated with pure water and iso-octane which is one of the density-standard fluids, and then measurement uncertainty was evaluated to be or 0.024% whichever greater in density, 0.26 kPa or 0.022% whichever greater in pressure and 3 mK for temperature, respectively. The performance of the present measurement system was examined by measuring thermodynamic properties for refrigerant R134a. The experimental results were compared with available equation of state and confirmed to agree with it within for liquid densities while in pressure for the gas phase.
Keywords
This publication has 5 references indexed in Scilit:
- The IAPWS Formulation 1995 for the Thermodynamic Properties of Ordinary Water Substance for General and Scientific UseJournal of Physical and Chemical Reference Data, 2002
- Investigations on the limits of uncertainty of gas density measurements with vibrating tube densimetersMeasurement Science and Technology, 1998
- An International Standard Formulation for the Thermodynamic Properties of 1,1,1,2-Tetrafluoroethane (HFC-134a) for Temperatures from 170 K to 455 K and Pressures up to 70 MPaJournal of Physical and Chemical Reference Data, 1994
- Measurements of liquid, near-critical, and supercritical (p, ρ, T) of 1,1,1,2-tetrafluoroethane (R 134a) and of 1,1-difluoroethane (R 152a)The Journal of Chemical Thermodynamics, 1993
- Compressed liquid densities and saturation densities of chlorodifluoromethane (R22)Journal of Chemical & Engineering Data, 1992