Cogging torque investigation in permanent magnet synchronous motor used for electrical vehicles
Authors:
- 1 May 2013
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 20687966,p. 1-4
Abstract
The present paper presents an analysis regarding the influence of the form and arrangement of permanent magnets on the value of the cogging torque for a surface permanent magnet synchronous motor, designed for the direct drive of the wheels of a vehicle. There are taken into consideration influences caused by: the constructive form of the magnets, the ratio between the pole-arc and the pole-pitch, the opening of the stator slots, the introduction of additional slots on the stator teeth, the asymmetrical distribution of the permanent magnets. The study takes into consideration 2D models developed on the basis of the validated 2D model for the built machine. The authors present a few general conclusions valid for the construction type of the analyzed machine.Keywords
This publication has 12 references indexed in Scilit:
- Review of Design Solutions for Internal Permanent-Magnet Machines Cogging Torque ReductionIEEE Transactions on Magnetics, 2012
- Slot opening optimization of surface mounted permanent magnet motor for cogging torque reductionEnergy Conversion and Management, 2012
- Influence of slot opening width and rotor pole radius on the torque of PMSMRenewable Energy and Power Quality Journal, 2009
- Design Considerations of a Direct Drive Brushless Machine With Concentrated WindingsIEEE Transactions on Energy Conversion, 2008
- Cogging Torque Reduction in Permanent Magnet MachinesIEEE Transactions on Industry Applications, 2007
- Experimental verification of optimal flux weakening in surface PM Machines using concentrated windingsIEEE Transactions on Industry Applications, 2006
- Three-Phase Modular Permanent Magnet Brushless Machine for Torque Boosting on a Downsized ICE VehicleIEEE Transactions on Vehicular Technology, 2005
- Cogging Torque Reduction in a Permanent Magnet Wind Turbine Generator2002
- Design and finite-element analysis of an outer-rotor permanent-magnet generator for directly coupled wind turbinesIEEE Transactions on Magnetics, 2000
- An axial-flux permanent-magnet generator for a gearless wind energy systemIEEE Transactions on Energy Conversion, 1999