One-step TSV process development for 4-layer wafer stacked DRAM
Authors:
- 1 June 2021
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 673-679
Abstract
The 3D stacked DRAM is an essential key module for high-performance computing systems. However, the cost increase due to 3D stacking limits its applications. The current 3D stacking technology requires front-side and backside microbumps, temporary bonding and debonding, time-consuming chip stacking etc., as additional process steps. In this paper, a 4-layer one-step TSV fabrication process is studied, enabling only one-time TSV fabrication combined with bumpless wafer-to-wafer stacking. Multi-stack layer dry etching is successfully demonstrated with photoresist masks by optimizing Si, oxide, and Al etching. Sidewall angles were controlled in the order of $\text{Si} > \text{SiO}_{2} > \text{Al}$ to balance aspect ratio and TSV/Al-pad connection. Cu filling is done by electroplating, and right filling property and good contact between Al sidewall and TSV are confirmed by cross-sectional analysis.
Keywords
This publication has 5 references indexed in Scilit:
- A 16-GB 640-GB/s HBM2E DRAM With a Data-Bus Window Extension Technique and a Synergetic On-Die ECC SchemeIEEE Journal of Solid-State Circuits, 2020
- Trench Isolation Technology for Cost-effective Wafer-level 3D Integration with One-step TSV2020
- New Cost-Effective Via-Last Approach by "One-Step TSV" After Wafer Stacking for 3D Memory Applications2019
- 25.2 A 1.2V 8Gb 8-channel 128GB/s high-bandwidth memory (HBM) stacked DRAM with effective microbump I/O test methods using 29nm process and TSV2014
- Three-Dimensional Packaging Technology for Stacked DRAM With 3-Gb/s Data TransferIEEE Transactions on Electron Devices, 2008