Glass transitions of thin polymeric films: Speed and load dependence in lateral force microscopy
Authors:
- 1 August 2000
- journal article
- conference paper
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 113 (5) , 2043-2048
Abstract
The glass transition of thin polymeric films can be profitably studied using lateral force microscopy (LFM) if the system is calibrated regarding operational parameters, in particular the applied load and the scanning velocity. We have established that these two parameters significantly influence the occurrence of an apparent glass transition. In particular, we have found that the local pressure, applied by the LFM tip, is insufficient to generate a hydrostatic pressure effect causing an increase in the apparent transition temperature. In fact, at a constant scan velocity and for increased load, the apparent transition temperature decreases towards the actual bulk value. Further discussions in this article are based on viscoelastic theories. Critical time scales that are characteristic for sliding are compared to polymer relaxation times, and provide an estimate of the viscosity temperature dependence.Keywords
This publication has 9 references indexed in Scilit:
- Glass and Structural Transitions Measured at Polymer Surfaces on the NanoscaleJournal of Thermal Analysis and Calorimetry, 2000
- Confined Flow in Polymer Films at InterfacesLangmuir, 1999
- Probing Polymer Viscoelastic Relaxations with Temperature-Controlled Friction Force MicroscopyMacromolecules, 1999
- Correlation of Nanowear Patterns to Viscoelastic Response in a Thin Polystyrene MeltLangmuir, 1998
- Polymer Viscoelastic Properties Measured by Friction Force MicroscopyMacromolecules, 1996
- Variation of the Interfacial Shear Strength and Adhesion of a Nanometer-Sized ContactLangmuir, 1996
- Tribological Investigations Using Friction Force MicroscopyMRS Bulletin, 1993
- The pressure variation of the glass transition temperature in atactic polystyreneThe Journal of Chemical Physics, 1986
- Effects of Hydrostatic Pressure on the Mechanical Behavior of Polyethylene and PolypropyleneJournal of Applied Physics, 1969