Acid-etching and Hydration Influence on Dentin Roughness and Wettability
- 1 September 1999
- journal article
- research article
- Published by SAGE Publications in Journal of Dental Research
- Vol. 78 (9) , 1554-1559
Abstract
Adhesion of restorative and protective materials to dentin is an important requirement for operative and preventive dentistry. Wettability and roughness are dentin substrate conditions that are critical to establishing good adhesion. This study examined superficial and deep dentin for variations in water contact angle measurements and roughness for polished, etched, dehydrated, and rehydrated states. Superficial and deep dentin disks from 6 non-carious third molars were prepared for AFM (Atomic Force Microscope) observation, roughness measurement, and contact angle measurements following specific treatments: hydrated and polished, etched (10% H3P04), dehydrated (desiccator for 24 hrs); and rehydrated (in water for 24 hrs). Contact angles were measured by means of the ADSA (Axisymmetric Drop Shape Analysis) technique with filtered and purified water of surface tension 72.79 ergs/cm2. The AFM was used to quantify the intertubular roughness. Mean and SD of roughness and contact angle were calculated for each dentin state, and two-way Repeated Measures ANOVA with Tukey's HSD multiple comparisons were performed at p < 0.05. Wetting and roughness both increased after etching, with roughness tending to increase further while wettability dramatically decreased after desiccation. After rehydration, water contact angle values were equivalent to those of the etched condition. Although intertubular roughness did not depend on depth, lower water contact angles were found for deep dentin. Depth and dehydration resulted in altered dentin substrates with exposed hydrophobic moieties that could interfere with bonding to hydrophilic primer coats.Keywords
This publication has 18 references indexed in Scilit:
- The dentin substrate: structure and properties related to bondingJournal of Dentistry, 1997
- Atomic force microscopy of conditioning agents on dentinJournal of Biomedical Materials Research, 1995
- Mineral Distribution and Dimensional Changes in Human Dentin during DemineralizationJournal of Dental Research, 1995
- Effects of surface treatment on the free surface energy of dentinDental Materials, 1994
- Atomic-force microscopic study of dimensional changes in human dentine during dryingArchives of Oral Biology, 1993
- Atomic force microscopy of acid effects on dentinDental Materials, 1993
- Glass-ionomer cements as adhesivesJournal of Materials Science: Materials in Medicine, 1993
- Improving Bond Strength Through Acid Etching of Dentin and Bonding to Wet Dentin SurfacesThe Journal of the American Dental Association, 1992
- Automation of axisymmetric drop shape analysis for measurements of interfacial tensions and contact anglesColloids and Surfaces, 1990
- The effect of surface roughening of polymers on measured contact angles of liquidsColloids and Surfaces, 1984