The Effect of Ni and Sb Oxide Precursors, and of Ni Composition, Synthesis Conditions and Operating Parameters on the Activity, Selectivity and Durability of Sb-Doped SnO2Anodes Modified with Ni
Authors:
- 2 May 2013
- journal article
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 160 (8) , H405-H413
Abstract
This paper reports the effect of employing Ni & Sb oxide precursors (instead of chlorides) in the preparation of Ni/Sb-SnO2 anodes on the activity and selectivity of ozone production in 1.0M HClO4. The effect of catalyst loading, Ni content in the precursor solution, furnace temperature and constant current density vs constant cell voltage operation is reported. The optimum composition was found to be Sn: Sb: Ni = 100: 6: 1, giving a maximum current efficiency of ca. 38% at a current density of 100 mA cm−2, the latter higher than previously reported. The durability of anodes prepared using NiO and Sb2O3 at 550°C during electrolysis at 100 mA cm−2 in 1M HClO4 was found to be 200 hours, again significantly higher than Ni/Sb-SnO2 anodes prepared using the chloride precursors at lower temperatures.Keywords
This publication has 66 references indexed in Scilit:
- Electrochemical generation of ozone at PbO2-loaded platinum screensJournal of Solid State Electrochemistry, 2010
- Characterization of an electrochemical reactor for the ozone production in electrolyte-free waterJournal of Applied Electrochemistry, 2010
- n-Type TiO[sub 2] Thin Films for Electrochemical Ozone ProductionJournal of the Electrochemical Society, 2010
- Ex situ and in situ characterization studies of spin-coated TiO2 film electrodes for the electrochemical ozone production processElectrochimica Acta, 2009
- Highly Efficient and Long-Lifetime Ozone Water Production System Realized Using a Felt SeparatorJournal of the Electrochemical Society, 2009
- Effect of preparation procedure of Iro2–Nb2o5 anodes on surface and electrocatalytic propertiesJournal of Applied Electrochemistry, 2005
- Investigation of the properties of Ti/[IrO2–Nb2O5] electrodes for simultaneous oxygen evolution and electrochemical ozone production, EOPElectrochimica Acta, 2004
- Ozone generation via the electrolysis of fluoboric acid using glassy carbon anodes and air depolarized cathodesJournal of Applied Electrochemistry, 1993
- The electrochemistry of Magnéli phase titanium oxide ceramic electrodes Part II: Ozone generation at Ebonex and Ebonex/lead dioxide anodesJournal of Applied Electrochemistry, 1992
- The Anodic Evolution of OzoneJournal of the Electrochemical Society, 1982