A method for semi-continuous measurement of dissolved elemental mercury in industrial and natural waters
Authors:
- 12 May 2016
- journal article
- research article
- Published by Taylor & Francis in International Journal of Environmental Analytical Chemistry
- Vol. 96 (7) , 609-626
Abstract
Mercury in aqueous systems can be present in different chemical forms. Of these, dissolved elemental Hg(0) (DEM) is of great importance because it can readily be partitioned between air and water. Analytical methods used for determining DEM are conventionally based on removal of Hg(0) by purging, pre-concentration on gold and detection by either cold vapour atomic absorption (CV-AAS) or atomic fluorescence spectrophotometry (CV-AFS). At present, there is no agreed protocol for the measurement of DEM in aqueous samples. A new method is described here, which is based on continuous stripping of DEM by mercury-free nitrogen in a flow injection mode and detection by CV-AAS. The partitioning of DEM between aqueous and gas phases is largely dependent on the composition of the former. Moreover, calibration using the standard addition method is not possible due to the reactivity of DEM introduced from calibration solutions. Calibration is therefore done by reference measurements using a manual method for DEM involving quantitative removal and CV-AFS detection. DEM is then determined in the water sample by applying the partitioning factor. The optimised method is precise, sensitive and linear over a wide concentration range. It has provided comparable results with the manual method when applied on board a research vessel in the Mediterranean Sea (0.02–0.05 ng L−1) and during a pilot laboratory-scale experiment on industrial aqueous media from wet flue gas desulphurisation (WFGD) equipment (2–300 ng L−1).Keywords
This publication has 56 references indexed in Scilit:
- Quantifying uncertainty in measurement of mercury in suspended particulate matter by cold vapor technique using atomic absorption spectrometry with hydride generatorSpringerPlus, 2013
- Removal of Hg0 from flue gases in wet FGD by catalytic oxidation with air – An experimental studyFuel, 2010
- Elemental mercury vapour in air: the origins and validation of the ‘Dumarey equation’ describing the mass concentration at saturationAccreditation and Quality Assurance, 2010
- The role of flue gas desulphurisation in mercury speciation and distribution in a lignite burning power plantFuel, 2008
- Correlation for the Vapor Pressure of MercuryIndustrial & Engineering Chemistry Research, 2006
- In situ high temporal resolution analysis of elemental mercury in natural watersAnalytica Chimica Acta, 2001
- Mercury in the Atlantic Ocean: factors controlling air–sea exchange of mercury and its distribution in the upper watersDeep Sea Research Part II: Topical Studies in Oceanography, 2001
- The distribution and speciation of mercury in the South and equatorial AtlanticDeep Sea Research Part II: Topical Studies in Oceanography, 1999
- Sunlight-Induced Formation of Dissolved Gaseous Mercury in Lake WatersEnvironmental Science & Technology, 1994
- The accuracy of the vapour-injection calibration method for the determination of mercury by amalgamation/cold-vapour atomic absorption spectrometryAnalytica Chimica Acta, 1985