Influence of nano-silica and -metakaolin on the hydration characteristics and microstructure of air-cooled slag-blended cement mortar
- 10 May 2017
- journal article
- research article
- Published by Taylor & Francis in Geosystem Engineering
- Vol. 20 (5) , 276-285
Abstract
This study aims at enhancing the hydration characteristics and microstructure of cement mortar (CM) containing ground air-cooled slag (ACS), using nano-silica (NS) and nano-metakaolin (NMK) powder. Firstly, ordinary Portland cement (OPC) was replaced by 0, 5, 10, 15, and 20 wt.% ground ACS. CM was designed at 3:1 of sand: OPC/ACS ratio. The water to cement (W/C) ratio was adapted at 0.47. It was found that the CM containing 5 wt.% ACS showed the highest compressive strength and free lime content at 90-day of hydration. Meanwhile, significant reduction in compressive strength and free lime values was observed in case of CM containing 20 wt.% ACS. Different NS and NMK percentages (2, 4, 6 and 8 wt.%) were individually added to CM containing 20 wt.% ACS, in order to enhance its chemical and physico-mechanical properties. The results showed that the addition of 6 wt.% NS and 4 wt.% NMK led to increase the compressive strength of ACS-blended CM by ~116 and 42%, respectively, compared to the control sample (without ACS). The hydration products were identified using X-ray diffraction, differential thermal analysis, thermogravimetric analysis, and scanning electron microscopy.Keywords
This publication has 19 references indexed in Scilit:
- Physico-mechanical properties of high performance concrete using different aggregates in presence of silica fumeHBRC Journal, 2014
- Effect of crushed air-cooled blast furnace slag on mechanical properties of concreteJournal of Wuhan University of Technology-Mater. Sci. Ed., 2012
- Properties of concrete containing ground granulated blast furnace slag (GGBFS) at elevated temperaturesJournal of Advanced Research, 2012
- The influence of nano-silica on the hydration of ordinary Portland cementJournal of Materials Science, 2011
- Physical properties and reactivity of pozzolans, and their influence on the properties of lime–pozzolan pastesMaterials and Structures, 2010
- Mechanical properties and durability of mortar and concrete containing natural pozzolana and limestone blended cementsCement and Concrete Composites, 2007
- Influence of air-cooled slag on physicochemical properties of autoclaved aerated concreteCement and Concrete Research, 2005
- Engineering properties of amorphous silica as a new natural pozzolan for use in concreteCement and Concrete Research, 2005
- Mechanical properties and durability of concrete made with high-volume fly ash blended cements using a coarse fly ashCement and Concrete Research, 2001
- Influence of slag substitution on some properties of sand-lime aerated concreteJournal of Materials Science, 1986