A 0.5-V 1-Msps Track-and-Hold Circuit With 60-dB SNDR
Authors:
- Peter R. KingetPKPeter R. Kinget
- 26 March 2007
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 42 (4) , 722-729
Abstract
We discuss a design technique that makes possible the operation of track-and-hold (T/H) circuits with very low supply voltages, down to 0.5 V. A 0.5-V 1-Msps T/H circuit with a 60-dB SNDR is presented. The fully differential circuit is fabricated in the CMOS part of a 0.25-mum BiCMOS process, with standard 0.6-V VT devices, and uses true low-voltage design techniques with no clock boosting and no voltage boosting. The T/H circuit has a measured current consumption of 600 muAKeywords
This publication has 21 references indexed in Scilit:
- Ultra-low voltage circuits and processor in 180nm to 90nm technologies with a swapped-body biasing technique2004
- A 0.5-v 1--μW successive approximation adcIEEE Journal of Solid-State Circuits, 2003
- Switched-capacitor circuit techniques in submicron low-voltage CMOS2003
- A 1 V 1 mW digital-audio ΔΣ modulator with 88 dB dynamic range using local switch bootstrapping2000
- A 1.5-V, 10-bit, 14.3-MS/s CMOS pipeline analog-to-digital converterIEEE Journal of Solid-State Circuits, 1999
- Bootstrapped low-voltage analog switches1999
- A cascaded sigma-delta pipeline A/D converter with 1.25 MHz signal bandwidth and 89 dB SNRIEEE Journal of Solid-State Circuits, 1997
- Switched-opamp: an approach to realize full CMOS switched-capacitor circuits at very low power supply voltagesIEEE Journal of Solid-State Circuits, 1994
- A 10-bit video BiCMOS track-and-hold amplifierIEEE Journal of Solid-State Circuits, 1989
- An 8-bit 50-MHz CMOS subranging A/D converter with pipelined wide-band S/HIEEE Journal of Solid-State Circuits, 1989