Mechanical Properties of Additive Manufactured Ti-6Al-4V Using Wire and Powder Based Processes
Authors:
- Erhard BrandlEBErhard Brandl
- Christoph LeyensCLChristoph Leyens
- Frank PalmFPFrank Palm
- 8 December 2011
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 26
Abstract
Since 1986 several techniques of building up geometries layer by layer have been developed and successfully commercialized under numerous trade names. Today, not only prototypes are realized by these techniques, but serial production parts are envisaged. To achieve this progress, the development activities have to focus on the reliability and output material quality. Particularly for aerospace applications, the material quality is an all-dominant factor. In this paper, an electron beam based powder-bed process and a laser based wire-feed process are investigated. Microstructure, chemical composition, static tensile and high cycle fatigue properties of Ti-6Al-4V samples are presented and evaluated from an aerospace application point of view. The static tensile properties resulting from both processes are mostly comparable to properties of cast or wrought material depending on post heat treatment and test direction. Fatigue limits of all samples are similar to those of wrought material. The impurity levels of oxygen, nitrogen, carbon and hydrogen are below the maximum level of plate material (AMS 4911L). The wire-feed process leads to a material with fewer impurities than the powder-bed process.Keywords
This publication has 7 references indexed in Scilit:
- Mechanical properties of Ti-6Al-4V specimens produced by shaped metal depositionScience and Technology of Advanced Materials, 2009
- Deposition of Ti–6Al–4V using a high power diode laser and wire, Part II: Investigation on the mechanical propertiesSurface and Coatings Technology, 2008
- Deposition of Ti–6Al–4V using a high power diode laser and wire, Part I: Investigation on the process characteristicsSurface and Coatings Technology, 2008
- Titanium and Titanium Alloys2003
- Titanium2003
- Titan und Titanlegierungen2002
- Development of a direct metal freeform fabrication technique using CO2 laser welding and milling technologyJournal of Materials Processing Technology, 2001