A new green power inverter for fuel cells
- 25 June 2003
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 2, 727-733
Abstract
This paper presents a new grid connected inverter for fuel cells. It consists of a two stage power conversion topology. Since the fuel cell operates with a low voltage in a wide voltage range (25 V-45 V) this voltage must be transformed to around 350-400 V in order to invert this DC power into AC power to the grid. The proposed converter consists of an isolated DC-DC converter cascaded with a single phase H-bridge inverter. The DC-DC converter is a current-fed push-pull converter. A new dedicated voltage mode startup procedure has been developed in order to limit the inrush current during startup. The inverter is controlled as a power factor controller with resistor emulation. Experimental results of converter efficiency, grid performance and fuel cell response are shown for a 1 kW prototype. The proposed converter exhibits a high efficiency in a wide power range (higher than 92%) and the inverter operates with a near unity power factor and a low current THD.Keywords
This publication has 6 references indexed in Scilit:
- Input current controlled DC interconnection converter for fuel cell systems2002
- A ZVS clamping mode-current-fed push-pull DC-DC converter2002
- A fully protected push-pull current-fed DC-DC converter2002
- Fuel cell inverters for utility applications2002
- Fundamentals of Power Electronics1997
- Modeling current-programmed buck and boost regulatorsIEEE Transactions on Power Electronics, 1989