Galvanic Couple Current and Potential Distribution between a Mg Electrode and 2024-T351 under Droplets Analyzed by Microelectrode Arrays
Authors:
- 8 November 2014
- journal article
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 162 (1) , C12-C23
Abstract
The galvanic throwing power of bare and polymer coated Mg over a simulated bare AA2024 scribe was studied directly with diagnostic multi-electrode arrays, which enable the spatial distribution of cathodic current density to be elucidated. The galvanic current density over the AA2024-T351 coupled to Mg in various full immersion, thin layer, and droplet electrolyte geometries relevant to atmospheric field exposures was investigated during simulated atmospheric exposures. In these microelectrode studies, current and potential distributions extended somewhat more uniformly across a 5.75 mm long, simulated bare 2024-T351 scratch when the electrolyte layer was thick, continuous and more ionically conductive (i.e., higher salt concentration) in the absence of a polymer coating over the Mg. Current and potential distributions did not extend across simulated defects when the electrolyte became discontinuous or the ionic path became tortuous due to drying or the addition of a resistive polymer coating over the Mg. Additionally, galvanic protection is shown to intensify for short period of time during drying and re-wetting cycles at close distances between Mg and 2024-T351 rationalized to be caused by changing electrolyte conductivity, E-i behavior, and electrode area effects. The drying characteristics of individual salts were also shown to have an effect on the current and potential distribution as MgCl2 (due to its low deliquescence/efflorescence point of ∼35% RH at STP) was shown to be less susceptible to drying at low RH, thus extending the time into the drying cycle where the galvanic couple was active compared to pure NaCl or ASTM Substitute Ocean Water.Keywords
This publication has 46 references indexed in Scilit:
- Environmental Degradation of a Mg-Rich Primer in Selected Field and Laboratory Environments: Part 1—Without a TopcoatCorrosion, 2013
- Sacrificial Anode-Based Galvanic and Barrier Corrosion Protection of 2024-T351 by a Mg-Rich Primer and Development of Test Methods for Remaining Life AssessmentCorrosion, 2011
- Behavior of Magnesium-Rich Primers on AA2024-T3Corrosion, 2011
- Cathodic Corrosion Protection Performance of Mg-Rich Primers: Effect of Pigment Shape and Pigment Volume ConcentrationECS Transactions, 2010
- Investigation on dual corrosion performance of magnesium-rich primer for aluminum alloys under salt spray test (ASTM B117) and natural exposureCorrosion Science, 2010
- Use of Magnesium Alloys as Pigments in Magnesium-Rich Primers for Protecting Aluminum AlloysCorrosion, 2009
- Assessment of the corrosion protection of aluminium substrates by a Mg-rich primer: EIS, SVET and SECM studyProgress in Organic Coatings, 2008
- The use of multiple electrochemical techniques to characterize Mg-rich primers for Al alloysProgress in Organic Coatings, 2007
- Comparison of testing solutions on the protection of Al-alloys using a Mg-rich primerCorrosion Science, 2006
- Electrochemical behaviour of a Mg-rich primer in the protection of Al alloysCorrosion Science, 2006