Revealing the effects of aerosol deposition on the substrate‐film interface using NaCl coating
- 12 April 2019
- journal article
- research article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 102 (10) , 5763-5771
Abstract
Aerosol deposition is a feasible method of fabricating dense ceramic films at room temperature by the impact consolidation of submicron‐sized particles on ceramic, metal, glass, and polymer substrates at a rapid rate. Despite the potential usefulness of the aerosol deposition process, there are issues, such as deposition mechanisms and structure of the film‐substrate interface, that are not well understood. We have used complementary structural and microstructural analysis to capture the state of the substrate surface after the aerosol deposition process. The results reveal that modification of the substrate surface by the ejected submicron‐sized particles is essential for the formation of anchoring layer, thereby, a change in internal residual stress state and surface free energy of the substrate is required to deposit film using AD process. Our analysis also suggests that the adhesion between the metal substrate and ceramic particles is possibly contributed by both physical bonding and mechanical interlocking.Keywords
Funding Information
- Deutsche Forschungsgemeinschaft (DE1598/5)
This publication has 43 references indexed in Scilit:
- Growth Process of α‐Al2O3 Ceramic Films on Metal Substrates Fabricated at Room Temperature by Aerosol DepositionJournal of the American Ceramic Society, 2011
- Deposition mechanism of dry sprayed ceramic particles at room temperature using a nano-particle deposition systemActa Materialia, 2011
- Residual stress and thermo-mechanical properties of cold spray metal coatingsActa Materialia, 2011
- Molecular Dynamics Simulation on the Modification of Crystallographic Orientation in Fragmented Particles in the Aerosol-Deposition ProcessMATERIALS TRANSACTIONS, 2007
- Chemical bonding, interface strength, and oxygenelectron-energy-loss near-edge structure of theinterfacePhysical Review B, 2006
- Aerosol Deposition of Ceramic Thick Films at Room Temperature: Densification Mechanism of Ceramic LayersJournal of the American Ceramic Society, 2006
- Atomistic Simulation of the Aerosol Deposition Method with Zirconia NanoparticlesMATERIALS TRANSACTIONS, 2006
- Cubic Aluminum Nitride Transformed Under Reduced Pressure Using Aerosol Deposition MethodJournal of the American Ceramic Society, 2005
- Molecular Dynamics Simulation on the Single Particle Impacts in the Aerosol Deposition ProcessMATERIALS TRANSACTIONS, 2005
- Electrical properties of direct deposited piezoelectric thick film formed by gas deposition method annealing effect of the deposited filmsFerroelectrics, 1999