A Compact and Broadband Doherty Power Amplifier Without Post-Matching Network
- 31 October 2022
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 70 (3) , 919-923
Abstract
Post-matching network (PMN) dominates broadband Doherty power amplifier (DPA) design, but at the cost of large footprint. This brief presents a PMN-free, compact and broadband DPA based on dual-mode impedance transformer (IT) which can simultaneously realize a complex-to-real conversion at two frequencies. The conversion ratio of the IT is significantly increased while its fluctuation is reduced after collaborating a short drain bias. The dual-mode ITs are used as the output matching networks in the carrier and peaking paths. An out-of-phase 2nd harmonic injection path is constructed based on the inherent structure of the IT without additional bridge, resulting in enhanced saturated efficiency and output power at the upper band edge. A prototype circuit operating from 2.1 to 3.1 GHz is fabricated, and measured results show a 7-8.2 dB gain and 42.2-43.3 dBm output power at saturation. The 6-dB OBO and saturated efficiency is 42.3-52% and 60.4-67.7%, respectively. The area of the whole OMNs is only 19×37 mm2, indicating a significant size reduction, while the DPA’s performance is comparable with the PMN types.Keywords
Funding Information
- Research Grants Council of Hong Kong (11206820)
This publication has 18 references indexed in Scilit:
- Design of an 87% Fractional Bandwidth Doherty Power Amplifier Supported by a Simplified Bandwidth Estimation MethodIEEE Transactions on Microwave Theory and Techniques, 2017
- Generalized Theory and Design Methodology of Wideband Doherty Amplifiers Applied to the Realization of an Octave-Bandwidth PrototypeIEEE Transactions on Microwave Theory and Techniques, 2017
- A Broadband High-Efficiency Doherty Power Amplifier With Integrated Compensating ReactanceIEEE Transactions on Microwave Theory and Techniques, 2016
- Sequential Load-Pull Technique for Multioctave Design of RF Power AmplifiersIEEE Transactions on Circuits and Systems II: Express Briefs, 2016
- A Post-Matching Doherty Power Amplifier Employing Low-Order Impedance Inverters for Broadband ApplicationsIEEE Transactions on Microwave Theory and Techniques, 2015
- Highly Efficient RF Transmitter Over Broad Average Power Range Using Multilevel Envelope-Tracking Power AmplifierIEEE Transactions on Circuits and Systems I: Regular Papers, 2015
- An extended bandwidth Doherty power amplifier using a novel output combiner2014
- A Wideband and Compact GaN MMIC Doherty Amplifier for Microwave Link ApplicationsIEEE Transactions on Microwave Theory and Techniques, 2013
- A Transformer-Less Load-Modulated (TLLM) Architecture for Efficient Wideband Power AmplifiersIEEE Transactions on Microwave Theory and Techniques, 2012
- Analysis of High-Efficiency Power Amplifiers With Arbitrary Output Harmonic TerminationsIEEE Transactions on Microwave Theory and Techniques, 2011