CFD Thermo-hydraulic Evaluation of Liquid Hydrogen Storage Tank with Different Insulation Thickness of Small-scale Hydrogen liquefier
Preprint
- 9 August 2023
- preprint
- Published by MDPI AG in Preprints.org
Abstract
Accurate evaluation of thermo-fluid dynamic characteristics in tank are critically important for designing liquid hydrogen tank of small-scale hydrogen liquefier to minimize heat in-leak into the liquid and ullage. Due to the huge cost, most future liquid hydrogen storage tank designs will have to rely on predictive computational models for storage tank pressurization and heat-leak minimization. Thus, reliable on predictive numerical models to aid design process of tank design have been required. Therefore, in this study, in order to improve the storage efficiency of the small-scale hydrogen liquefier, a three-dimensional CFD model that can predict the boil-off rate and the thermo-fluid characteristics due to heat penetration has been developed. The prediction performance and accuracy of the CFD model is validated on the basis of the comparisons between its results and previous experimental data and a good agreement is obtained. To evaluate insulation performance of polyurethane foam according to thickness, the pressure change and thermo-fluid characteristics in a partially liquid hydrogen tank, subject to fixed ambient temperature and wind velocity, has been investigated numerically. Three different insulation thickness were considered to investigate not only interfacial characteristics between liquid and ullage but thermo-fluid dynamics in hydrogen storage tank for various heat-leak situation. The results indicate that as the insulation thickness becomes thinner and more heat penetration exists, natural convection by buoyancy develops stronger, so strong vortices are created near the interfacial zone by upward flow driven by buoyancy. In particular, as the amount of heat in-leak increased, wider and stronger heat accumulation was found in the top dished head area of the ullage area. In addition, it was confirmed that the CFD model developed in this study could well describe the phenomenon in which the temperature of the tank wall and the insulation mat increased at a faster rate due to faster heat transfer from the vapor and interface. In the future, the numerical model developed in this study will be used for optimizing insulation system of storage tank for small-scale hydrogen which is cost-effective and highly efficient.Keywords
All Related Versions
- Version 1, 2023-08-09, Preprints
- Published version: Fluids, 8 (9), 239.
This publication has 33 references indexed in Scilit:
- A numerical model for liquid–vapor transition in self-pressurized cryogenic containersApplied Thermal Engineering, 2021
- Sloshing hydrodynamic performance in cryogenic liquid oxygen tanks under different amplitudesApplied Thermal Engineering, 2019
- Thermodynamic performance of pre-pressurization in a cryogenic tankApplied Thermal Engineering, 2017
- Pressurization performance and temperature stratification in cryogenic final stage propellant tankApplied Thermal Engineering, 2016
- Thermal performance of foam/MLI for cryogenic liquid hydrogen tank during the ascent and on orbit periodApplied Thermal Engineering, 2016
- Influence of wall ribs on the thermal stratification and self-pressurization in a cryogenic liquid tankApplied Thermal Engineering, 2014
- Numerical study of natural convection in a liquefied natural gas tankJournal of Mechanical Science and Technology, 2012
- Experimental and numerical investigations of fluid flow and heat transfer in a cryogenic tank at loss of vacuumHeat and Mass Transfer, 2010
- Modeling and simulation of a class of liquid propellant engine pressurization systemsActa Astronautica, 2010
- Forced convection heat transfer correlations for flow in pipes, past flat plates, single cylinders, single spheres, and for flow in packed beds and tube bundlesAIChE Journal, 1972