Design and Validation of the Ankle Mimicking Prosthetic (AMP-) Foot 2.0
- 8 October 2013
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Neural Systems and Rehabilitation Engineering
- Vol. 22 (1) , 138-148
Abstract
Transtibial (TT) amputations, or below-knee amputations, are among the most frequently performed major limb removals. To replace the missing limb, numerous prosthetic devices were developed. A study of the state-of-the-art in TT prostheses shows that none of the commercially available devices are capable of mimicking an able-bodied ankle-foot complex. Still on a research level, some powered prosthetic devices have the potential to improve amputee walking experience, but still need heavy and bulky actuators to provide the necessary power of propulsion. With the AMP-Foot 2.0, the authors propose a new concept for an energy efficient, powered transtibial prosthesis. Its design enables the use of a low power actuator which stores energy in springs during the complete stance phase that can be released at push-off. Thanks to this, the size and weight of the actuator can be decreased considerably while the ankle still provides the full power necessary for forward propulsion. A prototype of the AMP-Foot 2.0 has been built and experiments with a transfemural amputee were conducted. The captured data is presented and analyzed throughout this paper.Keywords
This publication has 16 references indexed in Scilit:
- Passive Ankle-Foot Prosthesis Prototype with Extended Push-OffInternational Journal of Advanced Robotic Systems, 2013
- An Active Foot-Ankle Prosthesis With Biomechanical Energy RegenerationJournal of Medical Devices, 2010
- Compliant actuator designsIEEE Robotics & Automation Magazine, 2009
- Powered Ankle--Foot Prosthesis Improves Walking Metabolic EconomyIEEE Transactions on Robotics, 2009
- Powered ankle-foot prosthesisIEEE Robotics & Automation Magazine, 2008
- Design and Control of a Powered Transfemoral ProsthesisThe International Journal of Robotics Research, 2008
- A biomechatronical transtibial prosthesis powered by pleated pneumatic artificial musclesInternational Journal of Modelling, Identification and Control, 2008
- Design and Control of a Powered Knee and Ankle ProsthesisProceedings 2001 ICRA. IEEE International Conference on Robotics and Automation (cat. No.01ch37164), 2007
- Second generation pleated pneumatic artificial muscle and its robotic applicationsAdvanced Robotics, 2006
- Kinematic and Kinetic Variations of Below-Knee Amputee GaitJPO Journal of Prosthetics and Orthotics, 2002