The role of surface modification in digital printing on polymer‐coated packaging boards
Authors:
- 29 October 2004
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 44 (11) , 2052-2060
Abstract
Digital printing is increasingly being used for package printing. One of the major techniques of digital printing is dry‐toner electrophotography. This paper evaluates the printability of three different extrusion coatings used for packaging boards: low‐density polyethylene (PE‐LD), ethylene methyl acrylate (E/MA) and polyethylene terephthalate (PET). Extrusion coatings in general have an impervious, chemically inert, nonporous surface with low surface energies that cause them to be non‐receptive to bonding with toners. The most common methods used in improving the adhesion properties of polymer coatings are different surface treatments. These increase the surface energy and also provide the polar molecular groups necessary for good bonds between the toner and polymer molecules. The polymer coatings have been modified with electrical corona discharge treatment. The effects of corona on polymer surfaces and the correlation between surface modification and print quality have been evaluated. Results show that sufficiently high surface energy and surface‐charge uniformity are necessary for even print quality and toner adhesion. E/MA and PET have the required surface‐energy level without the corona treatment, but PE‐LD needs surface modification in order to succeed in the electrophotographic process. E/MA also has exceptional surface‐charge properties compared with PET and PE‐LD. Polym. Eng. Sci. 44:2052–2060, 2004. © 2004 Society of Plastics Engineers.Keywords
This publication has 16 references indexed in Scilit:
- Evidence for voltage drops at misaligned wafer-bonded interfaces of AlGaInP light-emitting diodes by electrostatic force microscopyJournal of Applied Physics, 2001
- Local potential and polarization screening on ferroelectric surfacesPhysical Review B, 2001
- Measuring minority-carrier diffusion length using a Kelvin probe force microscopePhysical Review B, 2000
- Measurements of electric potential in a laser diode by Kelvin Probe Force MicroscopyApplied Surface Science, 2000
- Charge, Polarizability, and Photoionization of Single Semiconductor NanocrystalsPhysical Review Letters, 1999
- Measurement of induced surface charges, contact potentials, and surface states in GaN by electric force microscopyApplied Physics Letters, 1999
- Scanning-electrostatic-force microscopy: Self-consistent method for mesoscopic surface structuresPhysical Review B, 1998
- Electrostatic force microscopy on ferroelectric crystals in inert gas atmospherePhysical Review B, 1997
- E.s.c.a. studies of corona-discharge-treated polyethylene surfaces by use of gas-phase derivatizationPolymer, 1985
- Corona‐induced autohesion of polyethyleneJournal of Applied Polymer Science, 1971