Flexural Response and Structural Efficiency of Hybrid Fiber-Reinforced Concrete Slabs
Open Access
Abstract
Concrete remains the most widely used construction material globally; however, its intrinsic limitations—low tensile strength, brittle behavior, and susceptibility to microcracking—necessitate performance enhancement for demanding structural applications. Hybrid fiber-reinforced concrete (HFRC) offers a promising solution, yet the optimal balance of steel fibers (SF) and polypropylene fibers (PF) for structural elements such as slabs remains insufficiently understood. This study experimentally investigates the flexural behavior of 42 reinforced concrete slabs (21 one-way and 21 two-way) incorporating systematically varied SF–PF volumetric ratios, advancing current knowledge by identifying performance-optimal hybrid configurations for each slab type. One-way slabs were tested under four-point bending and two-way slabs under three-point bending, with structural responses evaluated in terms of load capacity, cracking behavior, deflection characteristics, and failure modes. The results demonstrate that fiber dosage does not proportionally enhance strength, as excessive content leads to fiber balling and reduced workability—highlighting the need for optimized hybrid proportions rather than indiscriminate addition. Quantitative findings confirm significant performance gains with properly tuned hybrid mixes. For one-way slabs, the optimal combination of 0.7% SF + 0.9% PF achieved 115% of the ultimate load of the control specimen, demonstrating a substantial improvement in flexural resistance. Two-way slabs exhibited even greater enhancements: first-crack load increased by up to 213%, and ultimate load improved by 40.36%, while deflection capacity rose by 44.81% at first crack and 39.80% at ultimate load with the optimal 0.9% SF + 0.1% PF mix. Comparatively, two-way slabs outperformed one-way slabs across all metrics, benefiting from multidirectional stress distribution that enabled more effective fiber engagement. Overall, this study provides new insight into hybrid fiber synergy in RC slabs and establishes quantified optimal SF–PF combinations that significantly enhance load capacity, ductility, and crack resistance for both one-way and two-way systems.Keywords
This publication has 48 references indexed in Scilit:
- Development of deep neural network model to predict the compressive strength of FRCM confined columnsFrontiers of Structural and Civil Engineering, 2022
- Experimental and finite element analysis of hybrid fiber reinforced concrete two-way slabs at ultimate limit stateSN Applied Sciences, 2021
- The influence of expansive cement on the mechanical, physical, and microstructural properties of hybrid-fiber-reinforced concreteCement and Concrete Composites, 2019
- Synergistic effects of hybrid polypropylene and steel fibers on explosive spalling prevention of ultra-high performance concrete at elevated temperatureCement and Concrete Composites, 2019
- Mechanical properties of high strength concrete reinforced with metallic and non-metallic fibresCement and Concrete Composites, 2007
- Toughness enhancement in steel fiber reinforced concrete through fiber hybridizationCement and Concrete Research, 2007
- Influence of polypropylene fiber geometry on plastic shrinkage cracking in concreteCement and Concrete Research, 2006
- Performance of spalling resistance of high performance concrete with polypropylene fiber contents and lateral confinementCement and Concrete Research, 2005
- Strength properties of nylon- and polypropylene-fiber-reinforced concretesCement and Concrete Research, 2005
- Residual strength of hybrid-fiber-reinforced high-strength concrete after exposure to high temperaturesCement and Concrete Research, 2004