Identification of the Optimal Blank Holder Force through In-Line Measurement of Blank Draw-In in a Deep Drawing Process
Open Access
- 24 October 2023
- journal article
- research article
- Published by MDPI AG in Journal of Manufacturing and Materials Processing
- Vol. 7 (6) , 190
Abstract
During the forming process, variations in noise parameters can negatively impact product quality. To prevent waste from these fluctuations, this study suggests a method for the in-line optimisation of the deep drawing process. The noise parameter considered is the friction coefficient, assuming the variability in lubrication conditions at the blank–tool interface. The proposed approach estimates the noise factor variability during the process by tracking the draw-in of the blank at critical points. Using this estimation, the optimal blank holder force (BHF) is calculated and then adjusted in-line to modify blank sliding and prevent critical issues on the component. For this purpose, a Finite Element (FE) model of a deep drawing case study was developed, and numerical simulation results were used to construct surrogate models while estimating both the friction coefficient and optimal BHF. The FE model’s predictive capability was verified through preliminary experimental tests, and the control logic was numerically validated. Results show the effectiveness of this control type. By adjusting the BHF just once, a defect-free component is achieved. This method overcomes the limitations of feedback controls, which often need multiple adjustment steps. The time required to estimate the friction coefficient and the maximum time available for adjusting the BHF without causing defects was identified.Keywords
Funding Information
- Italian Ministry of University and Research (MUR) (F/310302/01-05/X56)
This publication has 30 references indexed in Scilit:
- Inline feedback control for deep drawing applicationsIOP Conference Series: Materials Science and Engineering, 2016
- Effect of material scatter on the plastic behavior and stretchability in sheet metal formingJournal of Materials Processing Technology, 2014
- A novel feedback control system – Controlling the material flow in deep drawing using distributed blank-holder forceJournal of Materials Processing Technology, 2013
- Design of sheet stamping operations to control springback and thinning: A multi-objective stochastic optimization approachInternational Journal of Mechanical Sciences, 2010
- Temperature dependent friction modeling for sheet metal formingInternational Journal of Material Forming, 2009
- Kriging metamodeling in simulation: A reviewEuropean Journal of Operational Research, 2009
- New framework for on-line feedback control of a deep-drawing operationJournal of Materials Processing Technology, 2006
- Closed-loop control of the blank holding force in sheet metal forming with a new embedded-type displacement sensorThe International Journal of Advanced Manufacturing Technology, 2004
- Development of process control in sheet metal formingJournal of Materials Processing Technology, 2002
- Closed loop control of the friction force. Deep drawing processJournal of Materials Processing Technology, 1997