Imaging of subsurface defects with surface wave SAFT based on an array pickup EMAT
Authors:
- 18 April 2024
- journal article
- research article
- Published by SAGE Publications in International Journal of Applied Electromagnetics and Mechanics
- Vol. 74 (4) , 415-428
Abstract
It is necessary to detect subsurface defects for a key metallic structural component especially a multilayer coating to ensure its structural integrity. In this paper, an imaging algorithm using the synthetic aperture focusing technique (SAFT) is developed for processing surface wave signals of array pickup electromagnetic acoustic transducer (EMAT) to improve its signal-to-noise ratio and detectability of subsurface defects. In addition, an array pickup unit of surface wave EMAT with gap configuration is proposed to receive multi-channel surface wave signals and is optimized by adjusting its coil configuration such as number, spacing and detection distance in order to obtain better SAFT imaging result. Both simulation and measured EMAT surface wave signals are used for the defect imaging and all the results verified the validity and the efficiency of the proposed method.Keywords
This publication has 14 references indexed in Scilit:
- Ultrasonic inspection of curved structures with a hemispherical-omnidirectional ultrasonic probe via linear scan SAFT imagingNDT & E International, 2022
- 3D ultrasonic imaging based on synthetic aperture focusing technique and space-dependent threshold for detecting submillimetre flaws in strongly scattering metallic materialsNDT & E International, 2021
- Noncontact testing and imaging of internal defects with a new Laser-ultrasonic SAFT methodApplied Acoustics, 2021
- Quantitative ultrasonic testing for near-surface defects of large ring forgings using feature extraction and GA-SVMApplied Acoustics, 2021
- Characterization of planar flaws by an integrated approach using phased array and synthetic aperture focusing techniqueMeasurement, 2019
- Electromagnetic acoustic transducer optimisation for surface wave applicationsNDT & E International, 2019
- Experimental investigation of material nonlinearity using the Rayleigh surface waves excited and detected by angle beam wedge transducersUltrasonics, 2018
- Optimization of interdigital transducers for the generation of surface acoustic waves over a large bandwidth (20–125 MHz)Sensors and Actuators A: Physical, 2018
- The influence of various types of small defects on the fatigue limit of precipitation-hardened 17-4PH stainless steelTheoretical and Applied Fracture Mechanics, 2017
- Enhancement of signal amplitude of surface wave EMATs based on 3-D simulation analysis and orthogonal test methodNDT & E International, 2013