Modelling Commercial Vehicle Handling and Rolling Stability
Authors:
- 1 December 2005
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part K: Journal of Multi-Body Dynamics
- Vol. 219 (4) , 357-369
Abstract
This paper presents a multi-degrees-of-freedom non-linear multibody dynamic model of a three-axle heavy commercial vehicle tractor unit, comprising a subchassis, front and rear leaf spring suspensions, steering system, and ten wheels/tyres, with a semi-trailer comprising two axles and eight wheels/tyres. The investigation is mainly concerned with the rollover stability of the articulated vehicle. The models incorporate all sources of compliance, stiffness, and damping, all with non-linear characteristics, and are constructed and simulated using automatic dynamic analysis of mechanical systems formulation. A constant radius turn test and a single lane change test (according to the ISO Standard) are simulated. The constant radius turn test shows the understeer behaviour of the vehicle, and the single lane change manoeuvre was conducted to show the transient behaviour of the vehicle. Non-stable roll and yaw behaviour of the vehicle is predicted at test speeds >90 km/h. Rollover stability of the vehicle is also investigated using a constant radius turn test with increasing speed. The articulated laden vehicle model predicted increased understeer behaviour, due to higher load acting on the wheels of the middle and rear axles of the tractor and the influence of the semi-trailer, as shown by the reduced yaw rate and the steering angle variation during the constant radius turn. The rollover test predicted a critical lateral acceleration value where complete rollover occurs. Unstable behaviour of the articulated vehicle is also predicted in the single lane change manoeuvre.Keywords
This publication has 7 references indexed in Scilit:
- Handling Analysis of a Three-Axle Intercity BusSAE International Journal of Advances and Current Practices in Mobility, 2002
- Multi-Body Dynamics in Full-Vehicle Handling Analysis under Transient ManoeuvreVehicle System Dynamics, 2000
- Multi-body dynamics in full-vehicle handling analysisProceedings of the Institution of Mechanical Engineers, Part K: Journal of Multi-Body Dynamics, 1999
- The effect of cartilage deformation on the laxity of the knee jointProceedings of the Institution of Mechanical Engineers, Part H: Journal of Engineering in Medicine, 1999
- Motor Vehicle Dynamics: Modeling and Simulation1997
- Tires, Suspension and Handling, Second Edition1996
- Fundamentals of Vehicle Dynamics1992