Effect of strain rate on the mechanical properties of polycarbonate processed by compression and injection molding
Authors:
- 4 November 2021
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 62 (1) , 174-184
Abstract
The high impact strength of polycarbonate has been studied and exploited for many applications. However, the interaction between processing‐induced effects and the strain rate affects the mechanical behavior significantly. In this work, the effects of the processing‐induced thermal history, generated by either injection molding or compression molding, were characterized. Polycarbonate samples manufactured with the two processes were experimentally compared using quasi‐static and dynamic compression testing. The processing effects are further evaluated by combining a numerical calculation of the temperature history and a constitutive model to predict the yield strength of the glassy polymer. The constitutive modeling approach considers both the effect of the rate‐dependent and stress‐activated motion of the chain segments, and the strain‐hardening effect due to molecular alignment. The results indicate that the thermal history has a significant effect at low strain rates, while its influence is negligible in the dynamic range. The modeling effort allows estimating the yield strength with different accuracy depending on the strain rate values.Keywords
This publication has 36 references indexed in Scilit:
- Tensile behavior of polycarbonate over a wide range of strain ratesMaterials Science and Engineering: A, 2010
- Predicting the Long‐Term Mechanical Performance of Polycarbonate from Thermal History during Injection MoldingMacromolecular Materials and Engineering, 2009
- Processing‐induced properties in glassy polymers: Application of structural relaxation to yield stress developmentJournal of Polymer Science Part B: Polymer Physics, 2006
- Strain-hardening behavior of polycarbonate in the glassy stateJournal of Rheology, 2000
- The Influence of Intrinsic Strain Softening on Strain Localization in Polycarbonate: Modeling and Experimental ValidationJournal of Engineering Materials and Technology, 1999
- Process‐induced residual stresses in compression molded UHMWPEPolymer Engineering & Science, 1999
- The computation of properties of injection-moulded productsProgress in Polymer Science, 1995
- Residual stresses in injection molded polycarbonate rectangular barsPolymer Engineering & Science, 1993
- Solid state processing of polymers: A reviewAdvances in Polymer Technology, 1993
- The Temperature Dependence of Relaxation Mechanisms in Amorphous Polymers and Other Glass-forming LiquidsJournal of the American Chemical Society, 1955