Abstract
In structures involving faulted crystalline basement and folded sedimentary cover rocks, an understanding of the geometry of the folded and faulted sedimentary cover rocks enables a unique interpretation of the basement fault, provided that three critical assumptions are valid: (1) Basement deformation was primarily by rigid-body rotation and translation on a single master fault, which in many cases is completely masked near the basement-cover contact by the development of a zone of subsidiary splays, brecciation, and cataclastic flow. If this assumption is valid, the initial hanging-wall and foot-wall cut-off points probably will not be observable, but must, for reconstruction purposes, lie in the projected hanging-wall and footwall planar basement surfaces. (2) The structure balances locally; shortening of the cover was in direct response to and exactly equal to shortening of the basement. If so, then any accurate determination of predeformation bedding length is also an accurate determination of predeformation basement length in a given cross section. It follows that any cut-off point selected in the hanging wall has a corresponding cut-off point fixed in the footwall. (3) Volume changes accompanying deformation are negligible or can be estimated. Assumptions 1 and 2 permit the establishment of a family of potential faults, each of which satisfies the requirement that basement length was equal to the measured bedding length. Only one of those potential faults satisfies the further requirement that the postdeformational cross-sectional area of each unit must either be equal to the pre-deformational area or must reflect any established or assumed volume change. Restoration of the hanging wall establishes three points that define the trace of the fault in the cross section. In the case of a rotated block, the three points are nonrectilinear and define the curvature of the fault plane. In summary, the three assumptions constrain the interpretation to a unique solution of the master fault with respect to dip, position in the cross section, and curvature (if any).