43μW 6GHz CMOS Divide-by-3 Frequency Divider Based on Three-Phase Harmonic Injection Locking
Authors:
- 1 January 2006
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 183-186
Abstract
A harmonic injection-locked divider (HILD) is effective for realizing a low-power phase-locked loop (PLL) circuit because the high-frequency output of a voltage-controlled oscillator (VCO) is down-converted into a low-frequency signal instantaneously. Conventional resonator-based HILDs, however, occupy a large chip area and exhibit a narrow locking range because either an LC or short-stub resonator is required. Ring-oscillator-based HILDs, on the other hand, operate at a relatively low frequency, again with a narrow locking range. In this study, a new HILD based on three-phase harmonic injection locking is proposed, which realizes a small chip area, a low power consumption, and a wide locking range. As a result of fabrication with 0.18 μm CMOS, a divide-by-three HILD is realized with a power consumption of 43 μW, a maximum operating frequency of 6 GHz, and a locking range of 80% at a supply voltage of 0.7 V. The core size is 10.8 μm x 10.5 μm.Keywords
This publication has 7 references indexed in Scilit:
- A 16-to-18GHz 0.18-m Epi-CMOS Divide-by-3 Injection-Locked Frequency Divider2006
- W-band divide-by-3 frequency divider using 0.1 µm InAlAs/InGaAs metamorphic HEMT technologyElectronics Letters, 2005
- A 44-/spl mu/W 4.3-GHz injection-locked frequency divider with 2.3-GHz locking rangeIEEE Journal of Solid-State Circuits, 2005
- 55GHz CMOS frequency divider with 3.2GHz locking range2004
- A 50 GHz direct injection locked oscillator topology as low power frequency divider in 0.13 μm CMOS2004
- 1-GHz and 2.8-GHz CMOS injection-locked ring oscillator prescalers2002
- Superharmonic injection-locked frequency dividersIEEE Journal of Solid-State Circuits, 1999