The Effect of External Wall Insulation on Mold and Moisture on the Buildings
Open Access
- 21 April 2022
- journal article
- research article
- Published by MDPI AG
- Vol. 12 (5) , 521
Abstract
In this study, mold and moisture risk of external walls were investigated based on the six different wall types (block bims 1-2-3-4, hollow brick, and aerated concrete) and three different insulation materials (hemp wool, aerogel blanket, and extruded polystyrene). During the examinations, uninsulated and insulated external walls were taken into account according to moisture and mold growth depending on dew point temperatures. While calculating the optimum insulation thickness for uninsulated wall, degree-day and life cycle total cost methods were used. The natural gas, coal, and electricity were accepted as an energy source for heating and electricity was used for cooling. In the study, Izmir, Balikesir, Ankara, Kayseri, and Erzurum cities were selected to represent five climate zones according to Turkish insulation standard (TS 825). As a result of the calculations, the highest values of optimum insulation thickness were found in hemp wool and hollow brick for the electricity energy sources. It was determined as 0.118 m in Izmir and 0.202 m in Erzurum. For the insulated wall, the lowest indoor humidity value, where mold and moisture formation occur, was determined as 78% for Izmir and 69% for Erzurum.Keywords
This publication has 26 references indexed in Scilit:
- Determination of optimum insulation thickness for building walls by using heating and cooling degree-day values of all Turkey’s provincial centersEnergy and Buildings, 2016
- Building envelope with a new aerogel-based insulating rendering: Experimental and numerical study, cost analysis, and thickness optimizationApplied Energy, 2015
- Minimization of thermal insulation thickness taking into account condensation on external wallsAdvances in Mechanical Engineering, 2015
- Optimizing insulation thickness and analysing environmental impacts of aerogel-based thermal superinsulation in buildingsEnergy and Buildings, 2014
- The external walls of a passive building: A classification and description of their thermal and optical propertiesEnergy and Buildings, 2014
- Thermal, economical and environmental analysis of insulated building walls in a cold climateEnergy Conversion and Management, 2013
- Review of external convective heat transfer coefficient models in building energy simulation programs: Implementation and uncertaintyApplied Thermal Engineering, 2013
- Highly reflective coatings for interior and exterior steel cladding and the energy efficiency of buildingsApplied Energy, 2011
- LCC analysis for energy-saving in residential buildings with different types of construction masonry blocksEnergy and Buildings, 2011
- Optimization of insulation thickness for external walls using different energy-sourcesApplied Energy, 2006