Active Stabilization of Axial Compressors With Circumferential Inlet Distortion
Authors:
- 1 July 1998
- journal article
- Published by Wiley in Journal of Turbomachinery
- Vol. 120 (3) , 431-439
Abstract
This paper describes the first experimental validation of transfer function modeling and active stabilization for axial compressors with circumferential inlet distortion. The inlet distortion experiments were carried out in a three-stage low-speed compressor. Theory–experiment comparisons of steady performance, unsteady stall precursor, and forced response (transfer function) data were all used to assess a control-theoretic version of the Hynes–Greitzer distorted flow model. The tests showed good agreement between theory and data and demonstrated that a priori predictions, based on geometry and steady-state performance data, can be used to design control laws that stabilize rotating stall with inlet distortion. Based on these results, active feedback control has been used to stabilize the inlet distortion induced instability associated with rotating stall onset. The stabilization allowed stall-free operation to be extended below the natural (distorted flow) stall point by up to 3.7 percent for a 0.8 dynamic head distortion. For a 1.9 dynamic head distortion, 40 percent of the mass flow range lost due to inlet distortion was regained through active control. The paper elucidates the difficulties associated with active control with distortion, and introduces a new control law that addresses many of these challenges.Keywords
This publication has 12 references indexed in Scilit:
- Active Stabilization of Rotating Stall in a Three-Stage Axial CompressorJournal of Turbomachinery, 1994
- A Review of Nonsteady Flow Models for Compressor StabilityJournal of Turbomachinery, 1994
- Active Stabilization of Rotating Stall in a Three-Stage Axial Compressor1993
- Calculations of inlet distortion induced compressor flow field instabilityInternational Journal of Heat and Fluid Flow, 1989
- A Method for Assessing Effects of Circumferential Flow Distortion on Compressor StabilityJournal of Turbomachinery, 1987
- A Theory of Post-Stall Transients in Axial Compression Systems: Part I—Development of EquationsJournal of Engineering for Gas Turbines and Power, 1986
- Right half plane poles and zeros and design tradeoffs in feedback systemsIEEE Transactions on Automatic Control, 1985
- A Theory of Rotating Stall of Multistage Axial Compressors: Part II—Finite DisturbancesJournal of Engineering for Gas Turbines and Power, 1984
- A Theory of Rotating Stall of Multistage Axial Compressors: Part I—Small DisturbancesJournal of Engineering for Gas Turbines and Power, 1984
- Linear Optimal Control SystemsJournal of Dynamic Systems, Measurement, and Control, 1974