Rock mass classification and support design for the diversion tunnel at Surumana Dam, Central Sulawesi

Authors:

Abstract
This diversion tunnel at Surumana Dam, which is located in Central Sulawesi, is an essential part of the development of the dam. Its purpose is to temporarily redirect the flow of the river while the dam is being constructed. Through the use of surface mapping and borehole core analysis, this study provides a comprehensive engineered geological assessment along the intended alignment of the 525.78 m tunnel. Polymict breccia and conglomerate andesite were found to be the two most prominent lithological units. For the purpose of evaluating the quality of the rock mass, the Rock Mass Rating (RMR) rating system was utilized, with values ranging from 38 (poor) to 50 (fair). The tunnel alignment is segmented into zones that require individualized excavation and support solutions. These zones are organized according to RMR classes. In the inlet and center zones, poor-quality rock masses were often discovered. These rock masses necessitated top heading and bench excavation with close-spacing rock bolts (4 to 5 m), shotcrete with a thickness of 100 to 150 mm, and steel sets. Rock masses of a satisfactory quality, which can be discovered in the vicinity of the outlet, make it possible to use heading and bench methods with 4 m bolts and thinner shotcrete without the requirement of steel sets. At a 7 m span, the stand-up time estimates that are obtained from RMR values range from fifty to seventy hours for zones of low quality and from 24 to 100 hours for zones of fair quality. Based on these data, the appropriate excavation method, support design, and construction schedule may be calculated to ensure the tunnel’s stability and workers’ safety.

This publication has 12 references indexed in Scilit: