Calibration of a portal imaging device for high‐precision dosimetry: A Monte Carlo study
Authors:
- Harald KellerHKHarald Keller
- Michael FixMFMichael Fix
- Peter RüegseggerPRPeter Rüegsegger
- 1 October 1998
- journal article
- Published by Wiley in Medical Physics
- Vol. 25 (10) , 1891-1902
Abstract
Today electronic portal imaging devices (EPID's) are used primarily to verify patient positioning. They have, however, also the potential as 2D‐dosimeters and could be used as such for transit dosimetry or dose reconstruction. It has been proven that such devices, especially liquid filled ionization chambers, have a stable dose response relationship which can be described in terms of the physical properties of the EPID and the pulsed linac radiation. For absolute dosimetry however, an accurate method of calibration to an absolute dose is needed. In this work, we concentrate on calibration against dose in a homogeneous water phantom. Using a Monte Carlo model of the detector we calculated dose spread kernels in units of absolute dose per incident energy fluence and compared them to calculated dose spread kernels in water at different depths. The energy of the incident pencil beams varied between 0.5 and 18 MeV. At the depth of dose maximum in water for a 6 MV beam (1.5 cm) and for a 18 MV beam (3.0 cm) we observed large absolute differences between water and detector dose above an incident energy of 4 MeV but only small relative differences in the most frequent energy range of the beam energy spectra. It is shown that for a 6 MV beam the absolute reference dose measured at 1.5 cm water depth differs from the absolute detector dose by 3.8%. At depth 1.2 cm in water, however, the relative dose differences are almost constant between 2 and 6 MeV. The effects of changes in the energy spectrum of the beam on the dose responses in water and in the detector are also investigated. We show that differences larger than 2% can occur for different beam qualities of the incident photon beam behind water slabs of different thicknesses. It is therefore concluded that for high‐precision dosimetry such effects have to be taken into account. Nevertheless, the precise information about the dose response of the detector provided in this Monte Carlo study forms the basis of extracting directly the basic radiometric quantities photon fluence and photon energy fluence from the detector's signal using a deconvolution algorithm. The results are therefore promising for future application in absolute transit dosimetry and absolute dose reconstruction.Keywords
This publication has 29 references indexed in Scilit:
- Modeling dose distributions from portal dose images using the convolution/superposition methodMedical Physics, 1996
- The application of transit dosimetry to precision radiotherapyMedical Physics, 1996
- Verification and implementation of dynamic wedge calculations in a treatment planning system based on a dose-to-energy-fluence formalismMedical Physics, 1996
- Portal dose measurement in radiotherapy using an electronic portal imaging device (EPID)Physics in Medicine & Biology, 1995
- The use of an electronic portal imaging device for exit dosimetry and quality control measurementsInternational Journal of Radiation Oncology - Biology - Physics (IJROBP), 1995
- Input/output characteristics of a matrix ion-chamber electronic portal imaging deviceMedical Physics, 1994
- Dose calculation for photon beams with intensity modulation generated by dynamic jaw or multileaf collimationsMedical Physics, 1994
- Measurement possibilities using an electronic portal imaging deviceRadiotherapy and Oncology, 1993
- Are port films reliable for in vivo exit dose measurements?Radiotherapy and Oncology, 1992
- Application of the convolution method for calculation of output factors for therapy photon beamsMedical Physics, 1992