Design Equations for Lumped Element Balun With Inherent Complex Impedance Transformation
- 14 November 2017
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 65 (12) , 5162-5170
Abstract
This paper demonstrates a novel lumped design approach for complex impedance transformation, based on symmetry relaxation in the out-of-phase-compensated power splitter. In the modified topology, a total of four component values are used, of which two values analytically depend upon the other two, keeping the balance parameter maximally flat and independent of the source and load impedance, as well as of the balun internal components. From the condition of zero input reflection loss, the two other component values are also determined analytically, hence specifying all component values uniquely. A Monte Carlo sensitivity analysis predicts an amplitude imbalance, which in practice defines the limit in balance operational bandwidth, of better than ±1 dB, over a 20% bandwidth at 925 MHz operating frequency. Based on the design equations, demonstrators for four different design cases are fabricated, verifying the simulated performance.Keywords
This publication has 12 references indexed in Scilit:
- Lumped element balun with inherent complex impedance transformation2017
- Compact coupled‐line balun with complex impedances transformation and high isolationIET Microwaves, Antennas & Propagation, 2015
- Frequency Reconfiguration of a Dual-Band Phased Array Antenna With Variable-Impedance MatchingIEEE Transactions on Antennas and Propagation, 2015
- Analysis and design of complex impedance transforming marchand baluns2014
- An LTCC balanced-to-unbalanced extracted-pole bandpass filter with complex loadIEEE Transactions on Microwave Theory and Techniques, 2006
- Design of Broad-Band Lumped-Element Baluns With Inherent Impedance TransformationIEEE Transactions on Microwave Theory and Techniques, 2004
- Analysis and design of impedance-transforming planar Marchand balunsIEEE Transactions on Microwave Theory and Techniques, 2001
- Lumped-element compensated high/low-pass balun design for MMIC double-balanced mixerIEEE Microwave and Guided Wave Letters, 1997
- Power Waves and the Scattering MatrixIEEE Transactions on Microwave Theory and Techniques, 1965
- A New Wide-Band BalunProceedings of the IRE, 1957