Velocity and boundary shear in a wide compound duct
Authors:
- 1 September 1994
- journal article
- research article
- Published by Taylor & Francis in Journal of Hydraulic Research
- Vol. 32 (5) , 743-764
Abstract
Mean flow distributions of primary velocity and boundary shear stress were measured in a wide closed duct with a range of asymmetric compound cross-sections. The cross-sectional geometries included three different wall angles, vertical, 1:1 and 1:2 (vertical:horizontal) at the interface between the shallow and deep subsections. Results are presented for the effect of relative depth and wall angle upon primary velocity, boundary shear stress and friction factors. The particularly detailed boundary shear stress measurements indicate the presence of secondary flow on the flood plain even at the lowest relative depths, where it would not normally be identified by coarser spacing of the data.Keywords
This publication has 10 references indexed in Scilit:
- Distribution of Shear Force on Boundary of Smooth Rectangular DuctJournal of Hydraulic Engineering, 1994
- Automatic measurement of boundary shear stress and velocity distributions in duct flowJournal of Hydraulic Research, 1991
- Turbulent open-channel flows with variable depth across the channelJournal of Fluid Mechanics, 1991
- River Flow Simulation: Research and DevelopmentsWater and Environment Journal, 1990
- Turbulence measurements in a shear layer region of a compound channelJournal of Hydraulic Research, 1990
- Flow resistance in compound channelsJournal of Hydraulic Research, 1990
- Linear-Momentum Flux to Overbank SectionsJournal of the Hydraulics Division, 1970
- Calibration of the Preston tube and limitations on its use in pressure gradientsJournal of Fluid Mechanics, 1965
- On some aspects of fully-developed turbulent flow in rectangular channelsJournal of Fluid Mechanics, 1965
- A laboratory investigation into the interaction between the flow in the channel of a river and that over its flood plainLa Houille Blanche, 1964