The Effect of Microalloying of Nickel, RRA Treatment on Microstructure and Mechanical Properties for High Strength Aluminum Alloy
Authors:
- 17 April 2014
- journal article
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 925, 253-257
Abstract
High strength aluminum alloys Al-Zn-Mg-Cu-(0.1) Ni produced by semi-direct chill casting process were homogenized at different conditions then conducted heat treatment process which comprised pre-aging at 120°C for 24 h, retrogression at 180°C for 30 min, and then re-aging at 120°C for 24 h. Microstructural studies showed that add Ni (0.1 wt %) to the alloy will be forming Ni-rich phases such as AlCuNi, AlNi, AlNiFe and AlMgNi which provide a dispersive strengthening affected in the solid-solution and the subsequent heat treatments. The results showed that by this three-step process of heat treatments, the mechanical properties of aluminum alloys Al-Zn-Mg-Cu-(0.1) Ni were substantially improved. The highest attain for the ultimate tensile strength and Vickers hardness for the alloy sample after applied the retrogression and reaging process is about 545 MPa and 237 HV respectively.Keywords
This publication has 4 references indexed in Scilit:
- Effect of Minor Cr, Mn, Zr, Ti and B on Grain Refinement of As-Cast Al-Zn-Mg-Cu AlloysRare Metal Materials and Engineering, 2010
- Effects of retrogression heating rate on microstructures and mechanical properties of aluminum alloy 7050Transactions of Nonferrous Metals Society of China, 2010
- Effects and mechanisms of grain refinement in aluminium alloysBulletin of Materials Science, 2001
- Microstructures and tensile properties of spray-deposited high-strength aluminium alloysJournal of Materials Science, 1997