Microstructure and Mechanical Properties of a Low Carbon Bainitic Steel
Authors:
- 17 December 2012
- journal article
- research article
- Published by Wiley in Steel Research International
- Vol. 84 (4) , 352-361
Abstract
A low carbon bainitic steel with microstructure of granular bainite (GB), acicular ferrite (AF), and bainitic ferrite (BF) is obtained under different deformation and cooling rate. The effect of deformation and cooling rate on microstructural characteristics such as the type of the matrix, the size, and area fraction of the martensite–austenite (M–A) constituents is investigated. In addition, the nanohardness of these three kinds of matrix as well as that of the M–A constituents in them is characterized. Further, the effect of matrix and M–A constituents on strength–toughness balance is studied. Results indicate that deformation expands the transformation region. The size as well as the area fraction of the M–A constituent decreases with the increasing of the cooling rate. After deformation, the area fraction of the M–A constituents increases. Nanohardness of GB, AF, and BF increases orderly, but that of the M–A constituents in them decreases accordingly. The nanohardness of the M–A constituent is significantly affected by its carbon concentration. AF is the optimum microstructure having superior strength–toughness balance.Keywords
This publication has 31 references indexed in Scilit:
- Microstructure and mechanical properties of bainitic low carbon high strength plate steelsMaterials Science and Engineering: A, 2008
- In situ TEM study of the effect of M/A films at grain boundaries on crack propagation in an ultra-fine acicular ferrite pipeline steelActa Materialia, 2006
- Mechanical Properties of Low-Temperature BainiteMaterials Science Forum, 2005
- Very strong bainiteCurrent Opinion in Solid State and Materials Science, 2004
- Austenite to bainite phase transformation in the heat-affected zone of a high strength low alloy steelActa Materialia, 2004
- Continuous cooling transformation of undeformed and deformed low carbon pipeline steelsMaterials Science and Engineering: A, 2003
- Effect of Microstructure on the Yield Ratio and Low Temperature Toughness of Linepipe Steels.ISIJ International, 2002
- Ferritic Microstructures in Continuously Cooled Low- and Ultralow-carbon Steels.ISIJ International, 1995
- An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experimentsJournal of Materials Research, 1992
- The intermediate transformation of Mn-Mo-Nb steel during continuous coolingJournal of Materials Science, 1987