Flatness-based fault tolerant control
Open Access
- 15 December 2014
- journal article
- Published by Universidad Nacional de Colombia in DYNA
- Vol. 81 (188) , 131-138
Abstract
This paper presents a Fault Tolerant control approach for nonlinear flat systems. Flatness property affords analytical redundancy and permit to compute the states and control inputs of the system. Residual signals are computed by comparing real measures and the computed signals obtained using the differentially flat equations. Multiplicative and additive faults can be handled indistinctly. The redundant signals obtained with the differentially flat equations are used to reconfigure the faulty system. Feasibility of this approach is verified for additive faults in a three tank system.Keywords
This publication has 8 references indexed in Scilit:
- Fault tolerant control of a three tank system: A flatness based approach2013
- Motion planning for flat systems using positive B-splines: An LMI approachAutomatica, 2010
- Fault-tolerant Control Systems2009
- Error bounds in differentiation of noisy signals by high-gain observersSystems & Control Letters, 2008
- Fault-Diagnosis Systems2006
- Receding horizon control of vectored thrust flight experimentIEE Proceedings - Control Theory and Applications, 2005
- Flatness and defect of non-linear systems: introductory theory and examplesInternational Journal of Control, 1995
- Sufficient Conditions for Dynamic State Feedback LinearizationSIAM Journal on Control and Optimization, 1991