Influence of crystal form of ipratropium bromide on micronisation and aerosolisation behaviour in dry powder inhaler formulations
Authors:
- 1 September 2012
- journal article
- research article
- Published by Oxford University Press (OUP) in Journal of Pharmacy and Pharmacology
- Vol. 64 (9) , 1326-1336
Abstract
Objectives This study aimed to investigate the relationship between the mechanical properties of anhydrous and monohydrate ipratropium bromide (IB) crystals, their processing behaviour upon air‐jet micronisation and aerosolisation performance in dry powder inhaler (DPI) formulations. Methods IB monohydrate and anhydrous crystals were produced from seed crystals and supercritical carbon dioxide crystallisation, respectively. Young's modulus of anhydrous and monohydrate IB crystals was determined using nanoindentation. For air‐jet micronised crystals, the physicochemical and surface interfacial properties via the cohesive–adhesive balance (CAB) approach were investigated. These data were correlated to in‐vitro aerosolisation performance of carrier‐based DPI formulations containing either anhydrous or monohydrate IB. Key findings Particle size and Young's modulus of both crystals were similar and this was reflected in their similar processing upon micronisation. Particle size of micronised anhydrous and monohydrate crystals were similar. CAB measurements of the micronised particles of monohydrate or anhydrous forms of IB with respect to lactose were 0.70 (R2 = 0.998) and 0.77 (R2 = 0.999), respectively. These data suggested that both samples had similar adhesion to lactose, which correlated with their similar in‐vitro aerosolisation performance in DPI formulations. Conclusions Monohydrate and anhydrous crystals of IB exhibited similar mechanical properties and interfacial properties upon secondary processing. As a result, the performance of the DPI formulations were similar.Keywords
This publication has 29 references indexed in Scilit:
- Factors Affecting Defining the Quality and Functionality of Excipients Used in the Manufacture of Dry Powder Inhaler ProductsDrug Development and Industrial Pharmacy, 2008
- The effect of crystal morphology and mill type on milling induced crystal disorderEuropean Journal of Pharmaceutical Sciences, 2006
- The Cohesive-Adhesive Balances in Dry Powder Inhaler Formulations II: Influence on Fine Particle Delivery CharacteristicsPharmaceutical Research, 2004
- The Cohesive-Adhesive Balances in Dry Powder Inhaler Formulations I: Direct Quantification by Atomic Force MicroscopyPharmaceutical Research, 2004
- Influence of mechanical activation on the physical stability of salbutamol sulphateEuropean Journal of Pharmaceutics and Biopharmaceutics, 2003
- In vitro characterization of jet-milled and in-situ-micronized fluticasone-17-propionateInternational Journal of Pharmaceutics, 2003
- The influence of relative humidity on particulate interactions in carrier-based dry powder inhaler formulationsInternational Journal of Pharmaceutics, 2002
- Micronization of pharmaceutical substances in a spiral jet millPowder Technology, 1999
- Drug delivery to the respiratory tract using dry powder inhalersInternational Journal of Pharmaceutics, 1994
- Dry Powder Aerosols I: A New Powder Inhalation DeviceJournal of Pharmaceutical Sciences, 1971