Critical Conditions for Hydrodynamic Lubrication of Porous Metal Bearings
Authors:
- LubricationLULubrication
- Wear GroupWGWear Group
- A. CameronACA. Cameron
- V. T. MorganVMV. T. Morgan
- A. E. StainsbyASA. E. Stainsby
- 1 June 1962
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers
- Vol. 176 (1) , 761-770
Abstract
The theory of the operation of porous metal bearings as given in the 1957 Conference on Lubrication and Wear has now been extended. The analysis of a 360° porous bearing leads to a critical value of the Sommerfeld reciprocal 1/δ below which full fluid lubrication cannot be obtained. The magnitude of this critical value 1/Δc is found to vary only with the length to diameter ratio of the bearing L/D, and with the design variable Ψ, a dimensionless parameter dependent upon the Darcy permeability Φ, wall thickness H, and radial clearance c, and defined as + = Φ H/c3. In the absence of a full computed solution of the modified Reynolds equation, variation of the L/D ratio has been allowed for by applying the same correction factors that apply to non-porous bearings. Experimental work has been carried out using + values varying from 1.95 × 10-4 to 2.91 × 10-2 (a factor of 150) and within this range good agreement with the theory was obtained.Keywords
This publication has 1 reference indexed in Scilit:
- Progress of Fluid-Film LubricationTransactions of the American Society of Mechanical Engineers, 1929