Microstructure and tribological properties of Ni3Al–Cr3C2/Ni3Al micro-laminate composite films fabricated by electrohydrodynamic atomization technique
Authors:
- Ran WangRWRan Wang
- Jianxin DengJDJianxin Deng
- Zhihui ZhangZZZhihui Zhang
- Yang LuYLYang Lu
- Xuemu LiXLXuemu Li
- Jiaxing WuJWJiaxing Wu
Abstract
No abstract availableKeywords
Funding Information
- Key Research and Development Projects of Shaanxi Province (2019TSLH0315, 2020CXGC011003)
This publication has 35 references indexed in Scilit:
- Fabrication of high quality zinc-oxide layers through electrohydrodynamic atomizationThin Solid Films, 2012
- Ni3Al matrix high temperature self-lubricating compositesTribology International, 2011
- Sintering behaviour of nanostructured glass-ceramic glazesCeramics International, 2010
- Creep mechanisms of laminated alumina/zirconia-toughened alumina compositesJournal of the European Ceramic Society, 2009
- Microstructure and abrasive wear performance of chromium carbide reinforced Ni3Al matrix composite coatingSurface and Coatings Technology, 2007
- Microstructure, composition and oxidation resistance of nanostructured NiAl and Ni–Al–N coatings produced by magnetron sputteringSurface and Coatings Technology, 2005
- Designing a new family of high temperature wear resistant alloys based on Ni3Al IC: experimental results and thermodynamic modellingIntermetallics, 2004
- Determination of the sp3/sp2 ratio of a-C:H by XPS and XAESJournal of Non-Crystalline Solids, 1999
- On the micromechanics of low temperature strength and toughness of intermetallic/metallic microlaminate compositesActa Materialia, 1996
- Creep behaviour of a Ni-Ni3Al-Cr3C2 eutectic compositeActa Metallurgica, 1977