Quantitative analysis of cake characteristics based on SEM imaging during coagulation-ultrafiltration process
- 12 November 2019
- journal article
- research article
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 26 (36) , 36296-36307
Abstract
Cake formed by flocs is a crucial factor to affect membrane fouling during coagulation-ultrafiltration process. To investigate the role of floc properties on cake, cake characteristics under various coagulant dosage conditions were calculated by scanning electron microscope (SEM) imaging. Results found that one SEM image with × 5000 magnification could accurately estimate cake porosity with relative error lower than 5.00% for all conditions, whereas more SEM images with × 10,000 magnification or × 20,000 magnification should be applied to calculate cake porosity precisely. This could be explained by different pore information of SEM images with various magnifications. Compared to single SEM image with × 10,000 magnification and × 20,000 magnification, single SEM image with × 5000 magnification contained the most comprehensive pore information and slightly overestimated pore area for pore smaller than 0.4 μm2 due to lower resolution. To verify feasibility by SEM image evaluating cake characteristics, cake porosity calculated by SEM image and Carman-Kozeny equation were analyzed. The results showed that cake porosity estimated by these two methods were nearly the same, proving the feasibility of this method. Moreover, with the increase of coagulant dosage, cake porosity presented similar variation with floc average size, indicating that floc average size was likely to dominate cake porosity in this study. For pore characteristics, pore average characteristic length and pore average area were in accordance with floc fractal dimension, whereas pore fractal dimension and pore amount were consistent with floc average size. This gives specific information about the relation between floc properties and cake characteristics.Keywords
Funding Information
- the State Key Laboratory of Urban Water Resource and Environment (2012DX07)
This publication has 45 references indexed in Scilit:
- Improving ultrafiltration membrane performance with pre-deposited carbon nanotubes/nanofibers layers for drinking water treatmentChemosphere, 2019
- Mechanistic Study on the Role of Soluble Microbial Products in Sulfate Radical-Mediated Degradation of PharmaceuticalsEnvironmental Science & Technology, 2018
- Coagulation performance and membrane fouling of different aluminum species during coagulation/ultrafiltration combined processChemical Engineering Journal, 2015
- Effect of shear rate on aggregate size and structure in the process of aggregation and at steady statePowder Technology, 2013
- Membrane fouling control in ultrafiltration technology for drinking water production: A reviewDesalination, 2011
- NMR imaging of local cumulative permeate flux and local cake growth in submerged microfiltration processesJournal of Membrane Science, 2011
- Role of hydrophobic natural organic matter flocs on the fouling in coagulation-membrane processesSeparation and Purification Technology, 2008
- Effect of coagulation pretreatment on fouling of an ultrafiltration membraneDesalination, 2007
- Changes in fractal dimension during aggregationWater Research, 2003
- Influence of image resolution and thresholding on the apparent mass fractal characteristics of preferential flow patterns in field soilsWater Resources Research, 1998