Micro and Macro Deformation of Single Crystal NiTi
Authors:
- 26 March 2002
- journal article
- Published by ASME International in Journal of Engineering Materials and Technology
- Vol. 124 (2) , 238-245
Abstract
We present experimental results on the instrumented Vickers micro-indentation and compression of solutionized Ni-rich NiTi single crystals. The tests are conducted at room temperature where the solutionized Ti-50.9 at percent Ni material is 18 degrees above Af and the solutionized Ti-51.5 at percent Ni material is more than 100 degrees above Af. Aside from elastic deformation, it is discovered that dislocation motion and a reversible stress-induced martensitic transformation influence the micro-indentation response of Ti-50.9 at percent Ni, while the micro-indentation of Ti-51.5 at percent Ni only induces irreversible dislocation motion. The effect of the surface normal orientation on material hardness was negligible in the Ti-51.5 at percent Ni and followed trends anticipated by the activation of favorable slip systems in the Ti-50.9 at percent Ni. Compression tests on the identical Ti-50.9 at percent Ni samples revealed deformation by coupled stress-induced martensite and plastic flow, depending on the crystallographic orientation. The trends in hardness with surface normal orientation were not commensurate with the orientation dependence of the uniaxial compressive transformation or “yield” strength. The ramifications of the results in terms of comparing micro-indentation and macro-compression and the interactions between plasticity and the stress-induced martensitic transformation are discussed.Keywords
This publication has 40 references indexed in Scilit:
- Microstructure of NiTi shape memory alloy due to tension–compression cyclic deformationActa Materialia, 1998
- Effect of mechanical cycling on the pseudoelasticity characteristics of TiNi and TiNiCu alloysMaterials Science and Engineering: A, 1995
- Cyclic stress-strain characteristics of TiNi and TiNiCu shape memory alloysMaterials Science and Engineering: A, 1995
- From the EditorJournal of Intelligent Material Systems and Structures, 1995
- Fatigue of the Shape Memory Effect in thin Wires-Comparison between TiNi and CuZnAlJournal de Physique IV, 1995
- Thermodynamic analysis of the martensitic transformation in NiTi—II. Effect of transformation cyclingActa Metallurgica et Materialia, 1994
- Microindentations on W and Mo oriented single crystals: An STM studyActa Metallurgica et Materialia, 1993
- Overview No. 104 The physical and mechanical properties of NiAlActa Metallurgica et Materialia, 1993
- An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experimentsJournal of Materials Research, 1992
- A method for interpreting the data from depth-sensing indentation instrumentsJournal of Materials Research, 1986