Separation and flow unsteadiness control in a compression corner induced interaction using mechanical vortex generators: Effects of vane size and inter-device spacing
- 1 September 2022
- journal article
- conference paper
- Published by AIP Publishing in Physics of Fluids
- Vol. 34 (9) , 096105
Abstract
An experimental investigation was conducted to control separation characteristics of a 24° compression corner induced interaction in a Mach 2.0 flow using an array of mechanical vortex generators (VGs) with rectangular vanes (RRV) placed 6.8δ upstream of the interaction. The objective was to study the effect of (i) inter-VG spacing (s/h = 12, 9.5, 8.0, 6.1, 5.7, 5.5, 4.9, and 4.7), (ii) vane chord length (c/h = 7.2, 4.2, and 3.0), and (iii) vane angle (α = 24°, 20°, 18°, and 16°) in controlling the interaction and on the surface flow topology. These modifications reduce the projected area of VGs in the array from the conventional VG design of RRV2 (c/h = 7.2 and s/h = 9.5) to RRV8 (c/h = 3.0 and s/h = 4.7) by 41%. Reducing s/h also reduces the inter-VG region of the separation significantly that helps to achieve maximum reduction in the streamwise extent of separation up to 83% and in the peak rms value up to 80%. The former improves the overall pressure recovery from 3.0 to 3.4, thereby moving closer toward the inviscid value of 3.8. Surface flow topology shows that the VG array splits a single large spanwise separation bubble for no control into multiple smaller scale individual separation cells placed side-by-side all along the span of the interaction. This helps to reduce the magnitude of mass exchange imbalance across each individual separation cell and, hence, stabilizes the overall interaction relative to no control. The best VG configuration of RRV8 shifts the dominant frequency of fluctuations to approximately 2 kHz or St = 0.19, which is nearly an order of magnitude higher than that for no control.Keywords
Funding Information
- Aeronautics Research and Development Board
This publication has 44 references indexed in Scilit:
- Shockwave/Boundary-Layer Interaction Control on a Compression Ramp Using Steady Micro JetsAIAA Journal, 2012
- Supersonic-inlet boundary-layer bleed flowAIAA Journal, 1996
- Reduction of fluctuating pressure loads in shock/boundary-layer interactions using vortex generatorsAIAA Journal, 1995
- Flow structure in the wake of a wishbone vortex generatorAIAA Journal, 1994
- Numerical study of shock-wave/boundary-layer interactions with bleedAIAA Journal, 1993
- Effects of Sweepback on Unsteady Separation in Mach 5 Compression Ramp InteractionsAIAA Journal, 1993
- Unsteady nature of shock-wave/turbulent boundary-layer interactionAIAA Journal, 1988
- Wall pressure fluctuations in attached boundary-layer flowAIAA Journal, 1983
- Bleed Effects on ShockA3oundary-layer Interactions in Supersonic Mixed Compression InletsJournal of Aircraft, 1977
- An investigation of the effect of suction on hypersonic laminar boundary-layer separation.AIAA Journal, 1968