Effect of Thermal Cycle on Microstructure Evolution and Mechanical Properties of Selective Laser Melted Low-Alloy Steel
Open Access
Abstract
Low-alloy steel samples were successfully fabricated by selective laser melting (SLM). The evolution of the microstructure and the mechanical properties were investigated with different values of the energy area density (EAD). The results revealed that the initial solidification microstructures of the single tracks with different EADs were all martensite. However, the microstructures of bulk samples under different EADs were not martensite and differed significantly even from one another. When EAD increased from 47 to 142 J/mm2, the mixed lower bainite and martensite austenite microstructure changed to granular bainite; further, the morphology of bainite ferrite gradually changed from lath to multilateral. Moreover, with the increase of EAD, the grain size was remarkably reduced because of the increasing austenitizing periods and temperature during thermal cycling. The average grain size was 1.56 µm, 3.98 µm, and 6.31 µm with EADs of 142 J/mm2, 71 J/mm2, and 47 J/mm2, respectively. Yield strength and tensile strength of the SLM low-alloy steel increased with the increase in EAD; these values were significantly more than those of the alloys prepared by traditional methods. The microstructure of the SLM low-alloy steel samples is not uniform, and the inhomogeneity becomes more significant as EAD decreases. Simultaneously, when EAD decreases, the fracture mechanism changes from ductile to a mixture of ductile and brittle fracture; this is in contrast to the samples prepared by traditional methods. This study also found a stress concentration mechanism around large pores during plastic deformation that resulted in a brittle fracture. This indicates that large-sized pores significantly degrade the mechanical properties of the specimens.Keywords
Funding Information
- National Key R&D Program of China (2016YFB1100205)
- National Natural Science Foundation of China (51705532)
This publication has 32 references indexed in Scilit:
- Additive manufacturing of fine-structured copper alloy by selective laser melting of pre-alloyed Cu-15Ni-8Sn powderThe International Journal of Advanced Manufacturing Technology, 2018
- Preliminary investigation on selective laser melting of Ti-5Al-2.5Sn α-Ti alloy: From single tracks to bulk 3D componentsJournal of Materials Processing Technology, 2017
- In-situ synthesis of Ti2AlNb-based intermetallic alloy by selective laser meltingJournal of Alloys and Compounds, 2017
- Manufacturing Feasibility and Forming Properties of Cu-4Sn in Selective Laser MeltingMaterials, 2017
- Customized a Ti6Al4V Bone Plate for Complex Pelvic Fracture by Selective Laser MeltingMaterials, 2017
- Improved mechanical properties of the new Ti-15Ta-xZr alloys fabricated by selective laser melting for biomedical applicationJournal of Alloys and Compounds, 2016
- The influence of heat treatment on the thermomechanical response of Ni-rich NiTi alloys manufactured by selective laser meltingJournal of Alloys and Compounds, 2016
- Microstructures and mechanical properties of A356 (AlSi7Mg0.3) aluminum alloy fabricated by selective laser meltingMaterials & Design, 2016
- Review on manufacture by selective laser melting and properties of titanium based materials for biomedical applicationsMaterials Technology, 2015
- Densification behavior, microstructure evolution, and wear performance of selective laser melting processed commercially pure titaniumActa Materialia, 2012