Numerical Estimation of Suitable Gob-Side Filling Wall Width in a Highly Gassy Longwall Mining Panel
- 1 August 2018
- journal article
- research article
- Published by American Society of Civil Engineers (ASCE) in International Journal of Geomechanics
- Vol. 18 (8)
Abstract
Determining a suitable width of gob-side filling wall (GFW) is a major concern in the application of gob-side entry retaining (GER) technology in highly gassy coal mines. This paper presents a workflow for GFW width design based on a rigorous numerical modeling analysis. A meticulously validated numerical model was built to analyze the vertical stress, entry convergence, and plastic zone distribution across the GFW with various sizes. In order to ensure the reliability of the numerical model, a strain-softening model for GFW modeling and a double-yield model for gob modeling were implemented, and the relevant input parameters’ calibration was clearly illustrated. The results demonstrated that when the GFW’s width is 2.5 m, it possesses sufficient load-bearing capacity, and the entry convergence variation tends to stabilize. Consequently, the rational GFW width was estimated as 2.5 m. The field monitoring results demonstrate that a gob-side entry, with a 2.5-m-wide GFW, meets the cross section requirement for gas drainage. The proposed design workflow and modeling procedure can potentially be applied to other GER design under similar geological conditions.Keywords
This publication has 32 references indexed in Scilit:
- Stability and deformation of surrounding rock in pillarless gob-side entry retainingSafety Science, 2012
- The influence of roadway backfill on the coal pillar strength by numericalinvestigationInternational Journal of Rock Mechanics and Mining Sciences, 2011
- Three-dimensional analysis of coal barrier pillars in tailgate area adjacent to the fully mechanized top caving mining faceInternational Journal of Rock Mechanics and Mining Sciences, 2010
- Estimating the Strength of Jointed Rock MassesRock Mechanics and Rock Engineering, 2009
- A model for cable bolt-rock mass interaction: Integration with discontinuous deformation analysis (DDA) algorithmInternational Journal of Rock Mechanics and Mining Sciences, 2006
- An estimation method for cover pressure re-establishment distance and pressure distribution in the goaf of longwall coal minesInternational Journal of Rock Mechanics and Mining Sciences, 2004
- Estimation of rock mass deformation modulus and strength of jointed hard rock masses using the GSI systemInternational Journal of Rock Mechanics and Mining Sciences, 2004
- A study of the mechanical behaviour of coal for pillar designInternational Journal of Rock Mechanics and Mining Sciences, 1998
- The effect of rock mass confinement on the bond strength of fully grouted cable boltsInternational Journal of Rock Mechanics and Mining Sciences, 1992
- Suggested methods for determining hardness and abrasiveness of rocksInternational Journal of Rock Mechanics and Mining Sciences, 1978