Researchers have studied various types of respirable dust sampling filters to determine if the differential pressure across them at a constant air flow rate can be used to estimate the accumulated dust mass. Results suggest that glass fiber depth filters that allow the dust particles to penetrate well into the filter material have considerable merit. The correlation between the increase in differential pressure (AP) and dust mass (M) when using 37-mm glass fiber filters is linear, provided they are not loaded with more than approximately 5 mg of dust. Under these conditions, the relationship between differential pressure and dust mass can be described by the equation [°P(cm H2O) = 0.25 M(mg)]. Most of the data fall within ± 25 percent of a best-fit regression line and have a correlation coefficient (R2) of 0.88. These results were obtained using coal dusts from Pittsburgh, Upper Freeport, and Pocahontas seams mixed with various percentages (0 to 100%) of rock dust. The density of these dusts varies from approximately 1.3 to 2.5 g/cc. Particle size effects were studied using cyclones to load different filters at three different flow rates, providing three different particle size distributions from the common dust environments. The resulting differential pressures were then measured at a flow rate of 2 L/min. Limited testing using surface collecting filters made of polyvinylchloride or nylon showed poor differential pressure versus mass correlation compared with the glass fiber filters.