Implementation of a Transformerless Common-Mode Active Filter for Offline Converter Systems
Authors:
- 22 September 2009
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 57 (5) , 1772-1786
Abstract
This paper presents a study and practical implementation of an active filter employing a high-frequency (HF) power amplifier and passive-filter components to be connected to the ac power lines in order to mitigate common-mode conducted emissions of three-phase pulsewidth modulation converter systems. The filter topology is chosen from different possibilities listed in a literature survey and studied regarding practical implementation issues, where requirements for an HF power amplifier to be applied in active filtering are derived. Special attention is put on the stability analysis where the challenges for the feedback are discussed, and a simple feedback structure is proposed. Other feedback concepts are analyzed, and limitations posed by stability requirements are presented. A prototype is designed and built, from which mathematical and experimental results are obtained demonstrating the potential and limitations of such a system.Keywords
This publication has 15 references indexed in Scilit:
- An Improved Active Common-Mode Voltage Compensation Device for Induction Motor DrivesIEEE Transactions on Industrial Electronics, 2008
- Analysis of Insertion Loss and Impedance Compatibility of Hybrid EMI Filter Based on Equivalent Circuit ModelIEEE Transactions on Industrial Electronics, 2007
- Active EMI filters for automotive motor drives2005
- Novel three-phase CM/DM conducted emissions separator2005
- A new active common-mode EMI filter for PWM inverterIEEE Transactions on Power Electronics, 2003
- Design of an input filter for power factor correction (PFC) AC to DC converters employing an active ripple cancellation2002
- An active circuit for cancellation of common-mode voltage generated by a PWM inverterIEEE Transactions on Power Electronics, 1998
- Viability of active EMI filters for utility applicationsIEEE Transactions on Power Electronics, 1994
- Design of active ripple filters for power circuits operating in the 1-10 MHz rangeIEEE Transactions on Power Electronics, 1988
- Active Filters for 1-MHz Power Circuits with Strct Input/Output Ripple RequirementsIEEE Transactions on Power Electronics, 1987